My Bosch Maxx 900 won't start has power, water and door locks. Light comes on for active mode but nothing happens

No water getting in check water inlet pipe is not twisted or turned off eric992

no fuse try door inter lock

check door inter lock

http://www.appliancepartspros.com/bosch-washer-parts.html

I think the problem was a bad waterfill value. removethe water from the base
RINSE/DRY = Water filling fault (over or under filling)


regards
balisonu79

hello could be brushes on the motor. there are 2 black clips that sit on the motor after time these whare down just slide them out and slide new ones in good luck

shaun

I saw my repair man do the following, which you might try...
Open the door and simultaneously press & hold down the power button with the 2 buttons used on your model to "Cancel & Drain." If the unit comes on it now is in self-diagnosis mode. Release the buttons and close the door. The unit should start to fill with water. Press the power button to exit the mode.

To start unplug the machine power cord for ten minutes or longer, this will drain power from the machine and reset the electronic controls.

If this does not fix the problem check the following:

Check that the water supply at the back are opened and taking water into the machine.

Check that the door latch sensor is not stuck, and that door is well closed that is a frequent problem.

Check the drain hose and the drain lines, ensure that there is no blockage in there.

If this still does not work, then the machine has a faulty part that must be replaced, and must be tested by a qualified technician.

Use the phone number listed on the owner manual if you need to contact the repair service.

First question is does the display light up? If so then does the door lock? If the door is locking then the fuse for the washer that is on the back of the dryer hasn't blown. However if door won't lock, then check the fuse to see if it is open. This is a 208/240 volt washer and the display is the only part that doesn't need 208/240 volts. If fuse if find, then check the water screens in the fill hoses and clean them. This may be more of a control unit issue having failed, Hard to tell without knowing age of unit. Hope this helps