PICTURE HAS GREEN AND VIOLET OUTLINING ON FIGURES AND DOUBLE ON WORDING

your color engine is failing its also known as the optic block and they are very expensive to replace good luck google the optic block failure in these sets to better educate yourself with what your dealing with ok it most often blue that shows the failure but green and blue to and red

Bad convergence ICs STK392-110s use 180s , you also need to CK pico fuses in front and behind STK ICs they will look like resistors but are Green or Yellow 5amps/6amps they are fuses.
Mats has STKs 1-800-628-1118

there pretty simple red+ goes to keyed power wire. yello is the same keyed power wire.black ground. speake wire will be like two green two violet one will have black stripe that is the negitive solid color is positive green and green violet ant violet white and white blue and blue youll just have to figure out thr front and rear. blue wire is for amp remote turn on wire your speaker wires may be different colors but same idea

It is convergence out ICs failure problem and you need to replace two ICs in convergence board/ section in TV.
If you are not familiar with TV repair then call qualified TV tech to fix it.

see if the mirror in side is broke or cracked

Unit will require the 2 STK392-110 convergence amps to be replaced along with a couple of low ohm resistors.

Are you using styles? You could create a new style based on the existing style that has "Start at" and "1" as one of it's attributes. Then whenever you need to restart numbering, just apply the new style. Reply if you need help with styles

Sounds like your red is out of convergence. You may be able to adjust the convergence in the TVs menus. It may also be possible that the TVs convergence circuitry has gone bad. In that case it would be worth to have the TV repaired, convergence board are usually fairly inexpensive.

Degaussing means to demagnify. Not applicable with a projection tv. You have a severe convergence problem. Either a component failure, a speaker or other powerful magnet in very close proximity or someone figured out how to adjust (or misadjust) it.

hi there, its a color allignment problem, the adjusting ring is in the neck of the picture tube, the unit is on while adjusting it to the correct image. ty