Dear customer..here is the solution
Sometimes when you put a new (or alternate) voicemail system on a Norstar switch, The feature codes that accessed the old system stay in the KSU memory. If this is the case all of your feature codes will appear inactive even if the voicemail system is operating correctly.
To fix this issue you need to run an External Feature test (XFtest) to identify and remove the leftover codes from your KSU memory. You must have a programming set to access this menu (M7310, M7324, T7316).
Power down the Voicemail unit. Remove connection to voicemail ports from KSU.
1. Press [Feature] **938378 (XFtest). The password will be 266344 (Config).
2. Your display will read Feat code: and you will have options First and Exit.
3. Press First. The first stored feature code will appear, and you will have options Test, Back, and Next.
4. Press Test. Your options will read Remove and OK. Press Remove.
5. Once the feature code is removed, press Next to go to the next code.
6. Do this with all codes until your display reads None Registered
7. Release
Restore connections to the voicemail ports from the KSU. Power the system back up.
The feature codes will be restored to the correct defaults with the completion of the voicemail power-up cycle.
thank u
The feature codes did not restore to the defaults still reads none registered. They still come up inactive feature.
The feature codes did not restore to the correct defaults when the voice mail completed the power up cycle. They still show none registered and they still read inactive feature. please advise
×
Have you tested the phone, and tested the power supply through the phones menu?this is what the book says about inactive feature code.
Inactive Feature-
You have entered a feature code that is used
by an application program that your system
does not have.
Keep me updated.
Thanks,
Lee
Do you have the manual for the phones? In the manual there are several tests you can run on the phone to make sure they are working properly.
Let me know.
Thanks,
Lee
are these features that are programmed onto the CAP module buttons?
Thanks,
Lee
Sounds like the power outage might have wiped them out do you know how to reprogram the features?
Thanks,
Lee
Have you ran the external features test?
Thanks,
Lee
×
Do you mean that the options are grayed out with out any access??
If you go into your phone options, you'll want to do a "master reset". This will restore your phone to its original state. All of your features will be restored as well.
You can download the manual for a small fee here-
http://www.download-manual.com/shop/Nort...
×
2,694 views
Usually answered in minutes!
all phones work on all three lines for both incoming and outgoing calls. We have just lost all features, so have no ability to program or record greetings etc.
when we press features key and code (e.g. 983) nothing happens but the display of feature 983 or 981 then after a couple of seconds the message feature inactive. phone then returns to normal display.
Any help on this "feature inactive" problem?
×