Printer says, "There is a

Reset the print head. While out clean terminals with damp cotton wool. Should start after that if not probably faulty printhead,

plug your computer into the printer and download new drivers

Updating the firmware for your Lexmark Pro200 series will help fix this problem. You will need to get rid of the error first before you can successfully update your printer. Follow these steps: 1. Open the cover of the printer > Remove the printhead. If the printhead will not go to the center, turn off the printer and pull the printhead to the center. 2. Once you have the printhead removed, close the cover of the printer and turn on the printer. 3. It will ask you to "Open Cover to Install the Printhead". Press the Cancel (Red X) button. 4. It should take you back to the "Copy" menu. 5. Proceed with the firmware update. Just go to http://bit.ly/p205fw. There'll be more than one download for your model, try the top download first. 6. Once the firmware update is successful, reinsert the printhead by following the steps on your printer screen.
Source: There is a Problem with the Printhead

Updating the firmware for your printer will help fix the problem. You will need to get rid of the error first before you can successfully update your printer. Follow the steps below:
1. Open the cover of the printer > Remove the printhead. If the printhead will not go to the center, turn off the printer and pull the printhead to the center. 2. Once you have the printhead removed, close the cover of the printer and turn on the printer. 3. Once you have the printhead removed, close the cover of the printer. 4. It will ask you to "Open Cover to Install the Printhead". Press the Home icon. 5. It should take you back to the Main menu. 6. Proceed with the firmware update. Just go to www.lexmarklabs.com/firmware and choose the model number of your printer. 7. Once the firmware update is successful, go back to step 1 and install the printhead.
Source: There is a Problem with the Printhead

Make sure your printer is updated. The firmware update, available in the Lexmark website, will help fix printhead-related problems. Follow these steps: 1. Remove the printhead from the printer.

2. Reset the printer by unplugging the power adapter from the printer (should be the whole black box on the back of the printer), leave it unplugged for about a minute then plug it back in.
3. Once the printer is back on, it will ask for the printhead. Just disregard the message by pressing or CANCEL button on your printer screen. Do not install the printhead yet.
4. Then, please use this link: http://bit.ly/p705fw to download and run the firmware on your computer. Please make sure that the USB cable is attached from the printer to the computer while you do this.
5. Once the firmware update is complete, you may reinstall the printhead.

You must install new printhead, yours is defective.

Thanks.

Go to the Kodak site
Visit the page to download latest firmware
Install firmware

hi!!


try to re-install the driver of your printer
and then try to unhook the cartridge and then
clean up the nozzle used alcohol and cotton buds
and then placed it back the cartridge correctly!!!

I have been told that this is a Printhead, or Logic Board fault.

Git rid of it on customers by cleaning printhead(two screws then taking printhead out & cleaning connections, Replacing).

But now i have THS error 009 ??