Hi. I have a problem with my dishwasher ADG 6556.

http://www.appliancepartspros.com/repair-help/appliance-fault-codes.html

reset the panel by hitting normal-- heat dry NOT at the same time until all lights flash then push cancel and it should start. element is going bad

Hello

Wait for five minutes if the motor stopped itself and has been stopped for less than 10 minutes. This occurs in the event of an overload. If this is the case, the dishwasher will reset itself in approximately 5 minutes.

Turn off the dishwasher and unplug it from the power supply. Wait 10 minutes and restore power.

Select a "Hi Temp" wash cycle, followed by a heated dry setting on the dishwasher.
Repeat step 3. This will reset the dishwasher.

Hi
your model # is
6ADG 7554. You can purchase one at
http://www.manuals-in-pdf.com/index.php?main_page=advanced_search_result&keyword=whirlpool+adg+7554+manual&forward=plist
Have happ clean dishes

Refer user guide for the correct meaning!

Meanwhile Check all the dispensing compartments- salt - rinse-aid, free inlet water flow and the door close.

the eprom memory is brocken,the main board must be changed.

I have this same problem. Did u get it fixed, what was wrong? e-mail [email protected]

found outlet pipe was kinked, stopping water flow

Not too sure on that code, could be timer error. One thing to try would be to turn off the AC power to the unit and let it stay off for 15-30 minutes and then turn it back on. Sometimes if the unit takes a voltage spike it hashes the memory and resetting the power will clear it up, but to do this the voltage needs to turned off at the fuse/breaker box and not just the switch on the front. If you have the manual it may give ideas. I could not find the model no. you listed. Check to see if it is correct if resetting the unit doesn't help.