System error E0003

• Error E0003-0006
• Description: Center Thermistor low temperature detection at printing
  In the period from printing to last rotation, Main Thermistor 2 detected a temperature of 80 deg C or lower for more than 1 second.
• Remedy: Fixing Assembly error, Fixing temperature detection error 1. Check failure between the DC Controller PCB (UN09/ J12) and the Fixing Assembly (UN37/ J123, UN13/ J13) (trapped cable, open circuit, connector disconnection). -> Replace the part in the case of trapped cable/open circuit 2. Replace the Fixing Assembly 3. Replace the DC Controller PCB (UN09) NOTE: After performing the above remedy work, go through the following to clear the error: COPIER > FUNCTION > CLEAR > ERR

That appears to be on a Canon device. You probably need to narrow the following Google search to show only your device:

https://www.google.com/search?q=system+error+E0003&ie=utf-8&oe=utf-8&client=firefox-b-1

Canon iRC3380i Error Codes
E003-0002

Description

Error in the low temperature of the fixing unit
Detects the abnormally low temperature (open circuit) when turning ON the fixing heater.

Remedy

Clear the error in service mode: COPIER > FUNCTION > CLEAR > ERR.

https://watchonlineclub.com/jupiter-ascending-2015-hollywood-full-movie-watch-online.html

common problem and connect proply

You are signing on the wrong operator. Sign on the person who started the sale originally.

just clear error using additional * then (2+8 same time) again * after this process in screen displays copier select then function in function menu clear in clear menu select all option one by one and press ok after each selection and restart ur machine....

if problem continues replace the thermistor in the heater section

check fuser side if not hot trace ckt controller area, check for possible burn fuse.

press the additionel function button & press 2&8 buttons at once and again press additionel function .select COPIER and FUNCTION and CLEAR and ERROR andpress OK button.

Try this one from Canon:

Issue: ERROR LCD: System Error E003
Solution: Reset the unit-IC D/PC 1000 Series

Reset the unit

1. Slide the platen to the left.
   
   
2. Slide the platen back to the right until it locks in place.
   

if you have a some expirience with repairin you may change the fuse ,that is a fuse in your`s fixingf station.you may to open the printer,then renuve the fixing station and then dismount.Then you find a some thermal fuse *lookls like a snall rocket with two wire from them. 2A /103 deggres celsius