Reset opc belt count x502n lexmark - Lexmark X502N All-In-One Laser Printer

Please click on the link below to see instructions on how to go about the procedure.

http://bit.ly/p8oN00

For further assistance, please call Lexmark Technical Support.

hl-2700" OPC Reset
press GO and "+" at same time
press "+" until OPC BELT appears
press "SET"
that will reset the counter on the expensive OPC.
Since the "MFC-9420CN" is build on the same chassis and engine, the "OPC belt reset for the 9420CN" is as follows:
Press 1 and 7 at the same time
Press 1 to reset the life counter.

The error can either be caused by the OPC/OPC Marker assembly or the Main Motor assembly. Please follow the recommended troubleshooting steps:

1. Power the printer off, remove and reseat the OPC unit, and power the machine back on. Print a test page. If error continues, proceed to step 2.
2. Power the printer off and remove the OPC unit. Check the OPC Marker Sensor. If it is unsnapped or unplugged, reseat or replug it, and power the printer back on. Print a test page. If error continues, proceed to step 3.
3. Remove the OPC unit and check it for scratches or defects. Also check the the markers on the OPC to make sure they are not damaged. Is the belt scratched or damaged? If the OPC is at or near the end of its life, OPC unit must be replaced. If the belt is in good condition, contact Lexmark technical support (if printer is under warranty) or your local authorized service provider for assistance.

You may need to update the Lexmark X502n firmware. Here's an article in the Lexmark website on Firestarter message; Firestarter 4.0C:/VM/KILO/WORK@2; Will not print. Just click on this link: http://bit.ly/9RCTXp. Follow the instructions carefully. Hope this helps.

Here's the link on how to replace the Photodeveloper Cartridge on the Lexmark X500/X502: http://bit.ly/bzQQtH.

Here's the link on how to reset the photodeveloper (OPC) count on the X500/X502: http://bit.ly/9BxHqz.

Hope this helps.

When Fuser Life message on the screen of your Lexmark X502n printer is displayed, replace the fuser immediately, For your reference, check this article in the Lexmark website. Just click on this link: http://bit.ly/b4lggj . There are also links on that page on replacing the fuser and resetting the fuser page count. Hope this helps.

Unfortunately, the Lexmark X502n printer's support ends up to Mac 10.5 only, There are no drivers available for a Mac 10.6 versions. This would explain why you're having problem making it work with your computer. Hope I can assist you more on this.

Versuch mal bei Google met Ersatzteilnummer 0C500X29G

Try www.freeservicemanuals.com

Via the control panel (This is a Factory Reset)

1. Make sure the machine is not operating, then disconnect all the cables from the machine (except power cable).
2. Press the Menu or Menu/Set key on the control panel.
3. Press up or down navigation key to select LAN and press Set or Menu/Set.
4. Press up or down navigation key to select Factory Reset and press Set or Menu/Set.
5. Press 1 to select "Reset".
6. Press 1 to select "Yes".
7. The machine will re-start, re-connect cables once this is complete.