Error code 51 how to reset? - Brother DCP-330C All-In-One InkJet Printer

See error code list for this error
Error Codes > Sharp > MX2310U > Code L4-51 (printcopy.info)

See chapter 8 Troubleshooting of this manual for help
MX-2310U Operation-Manual GB (sharp.eu)

Error 51 I perform cleaning the steam generator and all source of water and I change battery also but still error is appearing to please give me solution

Possible solution here:
http://www.thecopiernetwork.com/showthread.php?19320-Konica-7033-Error-code-F-51-4

It is not always the machine. Sometimes it is a bad disc ... or a batch of them if they are from Memorex.

Do the MDs play on other machines?

12 just means the system was reset recently 55 mean end of codes so don't worry about them 2 however code 51 is an oxygen sensor error (O2 Sensor) a bad or shorted O2 sensor can cause it to run very bad and get poor gas mileage.

I can help you with your Brother MFC-210C error 51 problem.

Error 51 refers to a paper jam error.
Clear the paper jam to clear the error code.
If the error code will not clear after clearing the jam, resetting and powering off, the printer may require service.

I hope that helps.

Hi just read your posting.Error code 51 means you have a Recirculation Fault.This means while the machine is filling or washing it loses water.Error code 37 means you have Pump Block error which means the machine is not draining.Please look under the machine to the front right and you should see a pump with a red or black fan attached.Can you confirm this please? I think there is a problem with your diverter valve and the information on your type of pump will help me rectify this problem for you.Please reply with additional information on the type of pump in your machine.Looking forward to your reply.

Error 51 is a paper jam code. Remove the paper tray in the front and the jam clear cover in the back (the light gray plastic piece in the center of the rear of the printer) and pull out any paper you can see.

Once you've removed the paper, the jam code should clear on the display, but if it doesn't, try resetting the machine. If the jam code is still there, that means there is still paper somewhere inside the machine. Check again to make sure you didn't miss any, and also lift the scanner bed to see if you can see any paper under there. (To lift the scanner, lift up with the tabs on either side until the scanner locks into place.)

I got the error 51 once and it turned out the connector to the ink holder was loose so i put it in and error gone.If this not help you need clean the encoder strip.

hi karn..you need to disasemble your printer and clean your Maintenance unit....the coz of this error 51 is usually you are using competetor ink and then you have reset the counter (error 46) ,after you reset it, you need to change ink absorber if not it will bank those waste ink in the ink absorber and after it is full the waste ink have no place to store and it will jam the mantenance unit and the worse case it the ink maybe spoil other part of the printer go and find engineer  asap if not you need to replace new unit....