My rca will not hold a station.Sometimes the channel will hold then it starts quickly changing from station. I have cable and I use the remote from the cable box to tune channels.I need to reset the TV remote to the cable remote everytime to return to cable reception.This problem has just started about a month .Can you help?
I had the same problem and eventually found the solution. the tact switches behind the front panel buttons tend to leak when they get old causing them to activate by themselves. take off the back cover and the switches are mounted on a small circuit board that just clips in. remove the channel up and down switches from the board and clip it back in. your TV should work fine again. you of course will have no control with the front panel buttons but the remote will still work.
update: I found replacement tactile switches at Newark, part no.
PTS645TL50. I replaced all six switches on the board and my TV works
great now. I opened up one of the bad switches and noticed some
deposits between the contacts from the copper plated actuator. This was
probably causing a leakage of charge between the ground side and the
high side which would activate the switch. If the set is plugged in
then one side of the switch is always at high potential even when the
TV is off.
×
It seems to be continusly scanning channels and never ends
149 views
Usually answered in minutes!
i have the exact same problem. if you find a solution, please repost as will I.
I have the same problem.
Plus whenever I try to turn it off, it automatically comes right back on. I had to unplug it!
×