Will not fill. Checked all hoses are fine - Washing Machines

most likely either there is a crimp in the drain hose or water inlet hose. If this is ok then it might just be the way it has been installed in the new place.
Refer page 21 in the manualhttp://manuals.appliancesonline.com.au/dw60cdx2/dw60cdx2_user_guide.pdf

check to see if the screen is clogged were water hooks up to back of michine

Hi,

If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips...


Washing Machine Problems No Water

Washing Machine Fix Washing Machine No Water

heatman101

maybe a faulty water valve

water valve needs to be replaced...

it could be the inlet vale or simply push the tub back
sometimes they get out of alignment and it fills over the edge
the other thing could be a hole in the tub or even a hose off the bottom

bad lid switch

may be the sensor? I have the same model and I changed the sensor now it fills.

is the pressure switch working. that would be the next thing that i would check. it's mechanical, so you'll just have to see if it engages.

hi, it could be the inlet valve. This is usually what the hose fits to on the outside of the machine, and on the inside is the valve. MAKE SURE THE POWER IS OFF BEFORE you take the wires off the valve, then check for a reading on a ohms meter.ACROSS THE TWO TAGS, If no reading on the meter, the valve is gone. Regards, Tom.