My basement waste flotec pump it stopped working completely..,model se3200a,plus,where i can get manual for it

No, this pump does not natively turn on and shut off based on pressure. You need to add a pressure switch and tank. Flotec has the manual for the FP5172 here: https://www.pumpagents.com/pdf/FlotecPumps/Flotec-FP5172.pdf .

I hope this helps.

Cindy Wells

pump works fine..when plug in directly..sensor unit does not work all the time and is flooding the basement..how can i resolve this...where can i get just the sensor replaced

flotec intellipump does not work,new,out of box.does not detect water under any conditions.as we have flooding in r.i.,i thought i got lucky to find this pump in home depot in dartmouth mass.now i find i have a basement full of water,and a hastle trying to get my money refunded.

Check the pump to see if their is anything stuck inside. Check to see if motor is even spinning, it might hum...but not pump or spin.

You checked with the manufacturer ans struck out ... correct?

Check here: http://manuals-market.com/

this pump needs about 21/4" of water to operate properly, this pump will not remove all the water from the cover and will cycle on and off as it looses prime. If the motor turns completely off, it may be a an issue with low line voltage. you can try using a lager gauge extension cord to try and fix it, otherwise have an electrician test the line voltage.

Here is a pdf of the manual:
http://ec1.images-amazon.com/media/i3d/01/A/man-migrate/MANUAL000049529.pdf

the float has a mercury switch and that is what will make it turn on and off.  this ball sounds like it is not working correctly.  you will have to replace it.  just the ball

should be in drain basin to work properly and check that float moves freely.

Here is a link to your manual.

http://www.flotecpump.com/pdf/FP745.pdf

take strainer off to see if fravel stucj. if not, motor bearing may be shot. I would replace. I like wayne.