Heat or A/C does not turn on when car is remote started. As soon as you put the key in and turn it to the on pos. the heat or A/C comes on

This sounds like the heat sensor in the engine cooling system is failing/has failed completely (internal switching contact remains closed). The engine cooling fan should only come on at the prescribed heat temperature but will also remain active after shutting the engine down, if the engine temp is still above the prescribed temp. Regarding the A/C fan, this is most likely a wiring fault, possibly a short circuit with the car's ignition circuit.

recheck the wiring on the remote module for your heat it sound like you have it cross somewhere.

is it a after market remote starter,some times they do not turn on everything

The problem is that the tech who installed it didn't go to the heater accessory wire. This is a wire at the steering column that controls the power going to the heater to turn itself on.

does it have a remote start in it some times they can cause problems or you need a new ing switch and if the anti theft light comes on and the car wont start but turns over put the key in the ing switch and leave in on pos for 15 to 20 min to reset anti theft system.

Most likely only one of the cars 2 accessory circuits was powered up by the remote start. There definitely are 2 (red and white/blue). Please double check with multi-meter before just hooking up. But that should solve the no fan upon remote start.

try putting your key in the ignition leave in the off position, now remote start your car, if it starts then the transponder loop has to be adjusted

Look for a green 30 amp fuse in the remote starter harness it is probibly blown replace it and make sure it can't touch any metal

YOUR REMOTE START MAY NEED TO BE HOOKED TO AN ACCESSORY WIRE, IF IT CAN BE THAT IS

i would recommend replacing the ignition switch