Carrier XHB123D X/Y Series Heat/Cool Air Conditioner Logo
Posted on Nov 28, 2010

CARRIER INFINITY WEATHERMAKER WHERE IS THE RESTART SWITCH

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Dec 15, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Dec 15, 2010
Answers
6
Questions
0
Helped
2284
Points
13

Carrier Infinity systems, do not have a manual reset switch. It will have an automatic reset depending on the failure.
I would first, turn off the breaker to the indoor and outdoor units. Wait about 5 mins and turn the breakers back on. Doing this will reset the Control Board in the system. The system itself, is probably locked out.
This should get the system to come back on, However, you may have the problem come back and lock out the system again.
If this happens again, i would advise calling a Carrier dealer with Infinity systems to test it.

Hope this helps
Brian

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
2answers

Where is the Flame Roll-out switch reset located on the weathermaker 8000 fro carrier?

outside the burners a little semi round thing with wires to it and a push button reset
most of the time they are on the louver above the burner
0helpful
1answer

Furnace overload limit switch

Here is the service manual with wiring diagram.
5helpful
2answers
0helpful
1answer

Led indicator light on carrier weathermaker infinity says open fuse

Ok there is a small 3 amp or 5 amp fuse on the board inside the furnace. this is like an automotive fuse in a car
0helpful
1answer

I have a Carrier Weathermaker SXi. Furnance will not turn on. I shut power off and waited ten minutes and tried to restart. Codes flashing are 12, 31, 32, 33, 41, 42. Can this be started in emergency mode?

Emergency heat is made for this kind of situation.So yes you can.
now for the codes.
code 12= Blower on after power up
code 31=High heat pressure switch or relay didn't close or reopened
code 32=Low heat pressure switch or relay didn't close or reopened
code 33=limit circuit fault(Flame rollout switch is open)
code 41=board fault
code 42=control lockout

Please rate this solution
0helpful
1answer

NO HEAT???? freezing

go to the furnace, there should be a service switch on the outside of the unit.  make sure the door is on good, does the blower motor come on?
Not finding what you are looking for?

929 views

Ask a Question

Usually answered in minutes!

Top Carrier Heating & Cooling Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...