How to set up an intec controller to a playstation 3

It's not meant for the pc, but instead for the ps3.

From what I can tell, prices range from $9.99-19.99. Here are a few links to various sites selling this product.

http://www.amazon.com/Intec-Universal-Component-PlayStation-3-630420063056006304900/dp/B0014KKQWW

http://www.shopwiki.com/l/Intec-Component-AV-Cable-(PSP-Slim)

http://www.bizrate.com/wii-accessories/intec-cable-ps2/

Had a similar problem with an official Sony Dual Shock 3 recently. Turns out the solution was a very small pin hole sized reset button on the back of the controller. Have a look and see if yours has something similar, then try connect the charging cable again and sync. Worked on the official one for me anyway :/
Best of luck!

You need the intec usb connector not the cord!

I have the same problem. I disconnected the key, plugged the controller with its original cable. Turned the PS3 on, turning controller on, pressing Sync, connecting the key in PS3. At that state, the 4 leds start to flash slower as it detects the key. Problem is I can never connect to console. I mean I press Home and it never connects. Its been working fine before I updated PS3 to 3.5 version.

Remove the USB receiver from the ps3 console usb port. Turn OFF the ps3 console and the controller. Turn on the ps3. trun the controller to on. press the sync button on the controller. Insert the usb receiver to the usb port. Press Home button. Now I had two controllers one I had to return because no matter what i did it did not link but the 2nd one did this way

Connect it to the PS3, then power off the PS3. When you power it back on, that usually takes care of that for me

try opening it up to see if anything is loose

just plug it in it will charge even if the concel is off please rate

Putting batteries in controller
Turn on the PS3
Turn on controller
Press the sync button, the LEDs will flash rapidly
Insert the usb that comes with the controller, the LEDs flash slowly
Press the home button on the controller
READY.