Nokia 3500 isn't displaying the screen,since i took the battery out ,i've tried to insert it into the spirit so it can be dry.

There is a short in the phone that causes a high rate of battery discharge resulting in a overheating battery.
This cell phone is faulty and I suggest you get a new cell phone.

1) Try to dry the display with gun drier for 15 minutes with a distance about 12 inch.

2) Wait after you dry by 15 minutes, and try again.

3) If the problem persist the display board is faulty. you must replace.

go to www.repairclinic.com and buy it.

God bless you

1. The best thing to do is to factory reset the camera to be sure everything
is in the default setting. Look in the manual or menu to RESET the camera.
2. If this does not work, you can try is to remove the battery and wait a day,
then put the battery into the camera again and recheck.
3. If that does not help either, your camera might need repair/maintenance.

by using tester,check the voltage if there's a shortage. try to check/clean light/keypad ic/coil,use a magnifying lense to trace it some components are still corroded. use ultra sonic solution to clean the entire board. also keypad flex as well if some parts are broken or damage...








hope it helps..

Hello,

water has entered into the phone and you need to get the phone fully dried for it to work well again. I mean, there mustn't be any water inside the phone before it will turn on.

Remove the battery and clean it very well. After that, get a phone screw driver, unscrew all the phone screws, remove the phone cover in order to gain access to the phone panel. Gently remove/detach the screen from the phone board.

Get a methylated spirit and a soft tooth brush, dip the tooth brush into the spirit and use the brush to clean the phone board. Wash/brush every part of the board with the spirit.

After that, dry the board under an electric bulb or under sunlight. Allow it to dry very well. Let the board get hot. Then leave the board for 5mins or more to cool.

After that, couple back the phone, fix in the battery and try again. Then phone will definitely power on.

Let me know if it does not power on so that I can direct you on what to do next.

Your sincerely.

Elect_Comp.

Hi, when ever a phone drops inside the water, first remove the battery cause the battery life might be damaged,and also in that process the phone is still working because the battery is still inside the phone.

You will need to service the phone for the phone to be free from water,cause if the water dries inside the phone it will damage an IC or a chip inside the phone and it might cause more damage to the phone.

After, disassembling the phone is the next step.
Get a phone screw and unscrew the phone from the back by removing the battery and you will see some screws, unscrew possible screws and open the phone.

Get a methylated spirit and a small brush, remove the board of the phone and deep the brush inside the methylated spirit,brush gently on the board of the phone. After brushing, get a dryer to dry up the board of the phone and live it for a while to dry.

After some minutes,assemble the phone back and fix in the battery. Make sure during the process you are charging the battery of the phone.

I guess that's all you need.

Note: if the battery has stayed too too long on the phone and am sorry after the water splash, it might not come on after this all process, that means you will have to flash the phone because the battery might have damaged the memory of the board of the phone and will not power up the phone because the phone is too weak to power.

Flashing of the phone will restore back the phone memory.

For your phone screen not displaying, Water is still inside the screen, might have affected the screen display. You might need to replace the screen....

You can visit the below link to learn more about flashing of phones.



hubpages.com/hub/How-to-Flash-your-cell-phone


and

unlocktotalk.com/UnlockCodeInstructions.htm.

Hope it helped.

Feel free to pass your comment.

Thanks for using fixya.....

hey sorry about that. but from next time if you see that the phone is wet next moment remove battery and dry the phone never charge or try to use the phone with the battery on. now wat you can do is give the phone for a service. the guy will wash the phone with white petrol and then try starting it. if all the circuits are intact the phone will function back
bye

Hello, There is still water inside the phone that's why some part are still working and some not working yet.

What to do is this,

Unscrew the phone,
Get a Methylated spirit and a brush,
Bring out the board of the phone and use the methylated spirit to brush off remaining water on phone.
Keep under heat to dry off,
After board is dried, fix it back and screw back phone.

Am sure after doing this phone will work well.
But if phone still doesn't work ,that means water has damage some component inside the phone.
You will need to consult a phone technician for assistance.
Take care.

Hello,

loose the phone, and wash the phone panel with menthylated spirit and soft tooth brush. Dry phone panel with a bulb and don't wash the screen. You have to detach the screen before you wash the phone panel.

Likewise the the charging port and the battery terminal. Check if ite bridging in any way.

Allow it to dry, couple the phone back and try again.

Maybe you should test the phone with another battery.

Take care.

Yes your LCD is damaged by liquid, replace it look in the net where to get parts for it. Try trademe.