HP laserjet 5200 printer taking too much time to print a page..

Dear Sinclair
The freezing occurs due to two things.
1- when you command print file size is more than the buffer RAM of the printer. ( it will solved choosing page no. selection to print). If there is option to increase the RAM of printer, may be up graded.
2- Fixing temp. when exceeds predetermined temp. it takes a short time may be neglected.

Thanks.

Where the paper exits, there should be black tabs that lift up each time a page exits. They might be stuck in the up position, or possibly broken. Usually caused by aggressive removal of a paper jam.

Print half way test page.,chk leading edge is same as you noticed?..
If yes: Chk transfer roller, clean it, chk side locks..if required replace it..
If no: chk fuser Teflon sleeve., is there toner deposits in surface? Replace Teflon sleeve if available or else replace fuser assembly..
Half way test page:
browse: http://www.printertechs.com/printer-troubleshooting/halfway-test

41.2 error hp laser jet 5100
am from Ethiopia but when am check and replace the Formatter board ,beam not working but when am replacing the DC controller and all connecting cables to beam, then it was working god .

Try to set in printer setting.

Select Printer-->Properties-->Advanced-->Printing Preferences-->Paper/Quality

Set it A4 Paper...

The rear door is open (after creating a cleaning page). Close the rear door (at the back of the printer).


Good Luck!
Hope this helps!
CreativeTECH

clean the print heads and you will have better results.

http://www.hp.com/#Support

Follow the link and get the correct driver and get installed

Hi there,

• Unplug the printer cable from the computer.
• Unistall the printer drivers from Device manager and also unistall the all the printer appications
• restart the computer
• try to download drivers from the website
• after installing the cannon drivers and software it will ask you to connect the printer. 

• then you can connect the printer and print a test page.

Hope this help. Please Rate My Response! Thanks! 
Prem  

select the proper tray from the propeties of printer. it will take paper from that tray.