When turning dryer on, you can hear a clicking sound but, it won't come on GLGR331AS1

Control board probably needs replacement you can find the part here...

https://www.partselect.com/Models/FFRE4120SW/Manufacturer/4/Sections/Control-Panel/?ModelID=6901298&ModelNum=FFRE4120SW&mfgModelNum=&ManufactureID=4&Selected=E1595D82EF749006AEC1AD26B911C7D1B16785E2&Position=2&mfg=Frigidaire&Type=Dryer&Mark=2

Suggest you call their 888# to confirm with their tech's before throwiing parts at it.

Best to you.

Also these guys 800# but they show special order item.

https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dryer/1-2-2269837-/New/Frigidaire-Dryer-Won-T-Start-FFRE4120SW

Request from Frigidaire

If the igniter glows but it doesn't ignite, most of the time, it's the valve coils, most of the other times, it's the radiant sensor.

If the igniter doesn't glow, check your thermal fuse. If your thermal fuse is good, replace your igniter.

Good luck!

the start relay in the control panel is bad,the relays coil is moving this is the click you hear,but the main contacts in the relay are bad there are 4 wires to it 2 for the start switch and 2 for the main contacts

Check the door switch. Push it by hand and you should hear it click. If no click is heard, replace the door switch with this part.
If the switch is OK, then the only other problem will be with the thermal fuse located on the rear of the machine. Here is a link to that part.

You would not hear the click if the ignitor was bad. It won't click until the flame sensor get heated up by the ignitor. So that tells me the thermal fuse ain't melted. I would say them coils on the gas valve are the problem.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

';';

You have a bad motor. There should be a button you can press to make your dryer go while the door is open. Hold that and push the button in and then turn the drum. if that doesn't make it go then it is your motor

I would say the dryer has a failed central ball bearing. You can say it by turning the drum manually, with the belt not installed and hearing for the tipical "grainy" sound of the rusted or stucked bearing.

Look inside door and get the model number for me. Could be igniter, gas solenoids or temp control switch inside. Let me know, Thanks Sea Breeze