We have a magic chef washer that is letting the cold water run in constantly, even with the power off. also, it will not spin out now. model# cav2000aww. serial# 14430432ae.

if the motor runs but dont adjitate its poss.the coupler if it dont run may be in the lid swich or timer

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

Hi from retired Englishman in SW France,
(pre-typed for hot AND cold!)

If you have checked that the hot and cold water taps are turned on fully and the hoses are not kinked or squashed at the back, it is worth while checking both the hot and cold water inlet filters. Turn the taps off and remove both hoses at the washer end. Inside each inlet port there is normally a little filter which should just slide out. Clean if necessary and replace each one and the hoses. If after turning the taps back on there is no improvement, the problem is symptomatic of a malfunctioning hot or cold water control valve. Sorry but it needs a service call and a check that it isn't the control PCB ;-0(

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck,
John C

check to see if belt in inside not broke.

underneath the washer is a pully assembly kit . remove the belt ,the c clip and replace the pully kit about $ 20.00 cost for parts.

hi, you may find that the towels when wet are to heavy for the belt to grip the drum if it spins with normal clothes in you need to reduce the load when you wash your towels, hope this helps.

could be.pop the top and take off frount cover.run unit and look where water coming from.could alos inspect pump the pully dose come off on those an then drag metal to metal but normaly no water leak.also could be a bad tub seal you would see leaking from under neath

solenoid is causing it

you have to open it,at the bottom of the drum it has a either clear or black plastic hose that goes to pump held together with pressure clips remove them water will flow then ,it also will flood the aerea around it,so plenty of soil to soak it up

Pull the hot /cold hoses off and clean out the 2 screens in the valve.Put the hoses back on and re try washer .Problem solved?If still no hot water ,replace your water valve. Please Rate This !!!!

if the belt under the washer is intact then the transmission is bad. generally its time for a new washer unless its still under warranty