Water won't work but dryer does

GE Washer Not Agitating Repair Guide

www.appliance-repair-it.com/GE-washer.html

If your washer will not agitate or spin take a look at this page GE Washer Not ... If the washer fills up with water then doesn't do anything at all and you do not hear ... if this were the problem, the water would not stop running, over-filling the tub.

GE washer spin cycle not working - ApplianceBlog

www.applianceblog.com/.../217-GE-washer-spin-cycle-not-working

Mar 12, 2005 - 10 posts - ‎3 authors
I have a GE "Spacemaker Laundry" (Stackable) model number ... Today it filled withwater initially then stopped working all together when it ... Bad motor, something jammed/seized up holding the motor back from running?

Heating coil assembly could be bad. Heating Element Assembly 131475320

Hi Keith Knapp, I appreciate your inquiry!
I understand that your Frigidaire laundry center is not filling with water. It sounds like you could be having a problem within water valve, control board, or door switch. I would recommend having a technician out to your home to properly diagnose and repair your appliance. Hopefully this is helpful. -Matt

Hi rcdrivertim,

I believe the problem is the Lid Switch. Find it here:
http://www.appliancecarestore.net/whirlpool-amp-kenmore-genuine-washer-lid-switch-.html

If the Lid switch does not work, the machine will not switch over to cycling, thus not work.

You could always test the Lid switch by switching the attached wires to continuity, also known as bridging.

Hope this helps :-)

If this answered solved your problem, please accept it. If it did not, please comment and I will help you further.

Two screws on the very bottom, remove them and take something flat and insert it in the crack where the washer top is and the front panel. The front panel will slide down and out towards you...if no water is in the unit then push the tub back towards the rear and the motor will lift enough to work on it, replace the belt around the main pulley and then push the spring loaded pulley towds the left towards the main pulley and slide the belt onto the motor pulley...

Im haveing the same exact problem on the same exact machine... I have taken all the pannels off, and drained the water. I was wondering if there may be a way that the pump lost it's prime and needs to be re-primed? (wishfull thinking on my part.) There was no indication that the pump burnt out, it just stopped working instantly with no symptoms. The other functions seem to work, it will agitate the laundry, and then will just stop when it comes to the pump cycle. Any help is appreciated. Thank You.

3 year old GE stackable washing machine, had water coming out the top and would not drain or go through cycle, when shut off it drained a little but when turned on again it filled up and over flowed.

dryer tub loose

FLSE72GCS6 this model number is showin as a complete laundry center, not 2 seperate peices. in which casse there is no seperating them

replace the water pressure switch it is non ajustable for insurance purposes