Maytag LSE7806A Top Load Stacked Washer/Dryer Logo
Posted on Nov 03, 2010

Ihave maytag stackable the dryer works but washer stoped with water in it now the washer will not do any thing. i checked voltage at the harness coming out of control button and i have 110 volts at the pink wire but no power at lid swich.i cheked power at switch pink wire no power when i push the button down should i have 110 there ?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Nov 03, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Nov 03, 2010
Answers
6
Questions
0
Helped
451
Points
13

How many wires go into the lid switch?
If there's only two wires, short or connect them together and wrap the connection with electrical tape.
Then put the timer/programmer on the spin cycle and try if the water drains out and the machine goes to the spin phase.
If this works, then you have a defective lid switch/ lid locker

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My stackable unit quit filling with water. It still spins and drains. I have cleaned the screens out for the water hoses. I have unplugged it for a few. What else can I do to fix my washer?

Use a meter to test the water valve solenoid coils, make sure nobody turned the supply hoses off without you knowing. Did you recently replace the fill hoses or have work done on the machine? Maytag Washer Dryer Combo Water Inlet Valve WP22001274
0helpful
1answer

Older maytag stackable washer and dryer combo washer fills , washes and spins but water wont pump out

check for the pump belt broken or off,clogged pump or sock or small item clogging the tub outlet to pump hose. the pump pulley may have become loose on the shaft also
0helpful
1answer

The water in my stackable washer and dryer wont drain

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine2_bing.gif does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine2_bing.gif then checkout this tip...

Front Load Washing Machine2_bing.gif not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101
1helpful
1answer

I have a stackable Maytag. The water will not

I had a similar problem I just fixed. There is a fuse inside that keeps the water from filling if it's blown. Might try changing that first.
0helpful
1answer

The water pump won't start.. washer only works on spin

check the pump belt. tilt it back to see underneath or go through the back
0helpful
1answer

Wont fill and agatate

sounds like the water valve check for supply taps make sure there on test solenoid's on valve for ohms Resistance or closed circuitif open replace water valve
0helpful
1answer

Washer

THE DRYER WORKS OFF 220VOLTS,THE WASHER IS 110 VOLTS,CHECK WASHER PLUG BY PLUGGING IN A RADIO TO SEE IF YOU HAVE POWER,CHECK BREAKER BOX ALSO,MAKE SURE WATER IS ON TO,THANKS-MIKE
2helpful
6answers

Maytag Washer/Dryer stackable

well i am having about the same problem, but mine won't even fill, the dryer works but the washer won't fill or turn on at all. my husband had it all apart, too the control assembly to parts place and they said that hardly ever goes bad so it is still sitting unusable with no answer or money to spend on it in site.
1helpful
1answer

Maytag LSG7806A stackable washer/dryer - dryer not working

Deb, as long as the ignitor is glowing, it's probably your coils on the valve. Look at number 13 and 14 on the attachment. Part number for the booster coil is 306106 and 306105 for the secondary coil. Not a hard job, the coils slide right off after removing a screw and then replace the harness. Catriver...post back.
Not finding what you are looking for?

90 views

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...