F-5 error code on Kenmore elite HE3 45872

First try resetting it..Since Kenmore washers have capacitors and other components which hold the charge for some time, it is recommended to keep your washer disconnected for at least 5-10 minutes, so the residual charge is drained.
After waiting at least 5 minutes, power up your Kenmore washing machine again.
Conclusion When your Kenmore washing machine displays a phantom error code or some other issue, resetting it is the best way of action.
Hopefully, after following the instructions mentioned above, you'd be able to reset your Kenmore washing machine.

If that doesn't help you may have a broken or disconnected suppension rod..https://www.repairclinic.com/ProductDetail/1416243?symptoms=38

'LE' is a motor error.

https://www.google.com/search?q=Kenmore+Elite+Top+Load+washing+Machine+Displaying+LEI

..

if its a Kenmore model then this message says that the button control board has lost sight of the main control board , but its been my experience that this maybe able to be reset and it may never come back or it will not reset and the control board will need replaced (50/50)


cycling power may reset this

uE error code 79631512210 Kenmore Elite Washer - Sears ...

www.searspartsdirect.com > Ask an Expert

Jan 10, 2014 - uE error code 79631512210 Kenmore Elite Washer ' SearsPartsDirect. ... After unloading the washer completely, the machine attempts to rebalance the .... to ensure proper fit and to keep appliances running for years to come.

UE Error code on my front loading Kenmore washing machine

www.shopyourway.com > Manage My Life > Questions

Jun 13, 2011 - I have a Kenmore 3.5 cu. ft. front loading washing machine (model #4027) and it is 1 year old. ... what does the F35 error code on my kenmore elite front loading washing machine mean? F13 code on Kenmore Elite HE3 front loadingwashing machine.

hi
unfortunately the programmer is faulty

Analog sensor failure. Replace that puppy using this VIDEO GUIDE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

"Ld" (Long Drain) flashes
Is the drain hose kinked or clogged?
Press STOP/CANCEL to clear the display.
• "CA" or "Cl" (Current Limit)
Is the washer overloaded?
Press STOP/CANCEL to clear the display.

Here is a manual:

http://www.managemyhome.com/mmh/lis_pdf/OWNM/L0102048.pdf

See page 17.

f-1 error code,, replace main contol board ,,pressure swtich is loacted inside board would not fill drain and spin once replaced there will be no more problems, if machine is 2 yrs should be covered under warranty

I am getting F35 error code. What is the problem?

This error only shows in diagnostic mode, with power off choose any buttons except stop and power, press in intervals 5 seconds on and 5 seconds off until 88 appears and all light light up. If the user panel is faulted F 2 will flash in the display, press the same button you used to start diagnostics to jump to the next error code and once through 88 will flash and diagnostics will start. Sometimes once F2 flashes and the machine has not been repaired it will stick at that mode.