Frige temp went up to 62 and won't come back down to 40. Try resetting and unplugging several times. Suggestions?

Try the flow sensor which sits in the tank on the left handside

you will have to replace your thermostat of the fridge

you can find it near the light inside the unit

You may have a defective inverter=> WR55X10504 Inverter

The Monogram is complex and expensive so if you would like my assistance I will be glad to help. First unplug refrigerator and examine the inverter for burns or swollen capacitors. Here is one after the plastic was cut away to expose the inverters circuit board, notice the tops of the capacitors are swollen? PHOTO HERE Service Manual HERE
I will be here should you need my assistance or comments, Thanks Sea Breeze
Other parts store=> WR55X10504 Inverter

Clean the filter in the back of the unit, my did this too.

Try to unplug it again let it set 5 min and then plug it back in. If that doesn't do it you may have to replace the compressor relay where the wires hook to the compressor, thats a fairly easy fix on that unit.

Hi


Thanks for using FixYa. If the clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light flashes, all buttons are non responsive). It does this as a safety in case the element is broken and feeding electrical current into the water.

To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...

-high temp wash
-heated dry
-high temp wash
-heated dry



Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

I would suggest check the coils to make sure they are clean . Also check the fan which cools the compressor to make sure it is working . When you unplug , it gives the compressor time to cool down a bit , but after it restarts , it will get hot again and stop cooling .

PF usually refers to a power failure. You may have a loose connection. Unplug the dryer and check that all terminals are tight. That may confuse the board. If that is doesn't do it, your probably on the right line about the sensor.

Unplug the unit for a couple of minutes and restart. If this doesn't fix it, you may need to replace the computer board.