EPSON STYLUS PHOTO RX620, WILL NOT WORK; SERVICE REQUIRED. Pars insideyour printer are at the end of their service life. See your printer's documentation for details. How do I fix?

fault is caused by counter, which counts printed pages for reason of possible overflow of waste ink pads. To reset counter a free tool is available under::

http://www.ssclg.com/epsone.shtml

this tool has also other advantages of e.g. overdubbing cartridge codes ....

a german instruction for resetting the counter is available here:
http://www.druckerchannel.de/artikel.php?ID=1116&seite=13&t=schritt_7_zaehler_zuruecksetzen

make sure to have removed and replaced waste ink pads:
http://www.octoink.co.uk/pages/Epson-RX620.html

start program, choose printerport which is used for Epson rx620, choose Epson model rx620
close active window of program ssc -> program will be available by icon in right lower corner.
switch on printer
right mouse click on program icon in right lower corner will open options:
http://www.druckerchannel.de/artikel.php?ID=1116&seite=13&t=schritt_7_zaehler_zuruecksetzen#
choose according to picture

switch off printer / switch on printer

in case of not working at once retry

Epson programmed their printer to monitor the waste ink counter and your printer has reached the maximum value allowed, you have to reset your printer to clear the waste ink counter.

You may read the information regarding "end of life" and "waste ink counter" here: http://www.epson.com/cgi-bin/Store/support/InkPadsForm.jsp

To reset the counter, download re-setter program here, install and follow the instruction in the web site.

Good luck and thank you for using FixYa.

Epson programmed their printer to monitor the waste ink counter andyour printer has reached the maximum value allowed, you have to resetyour printer to clear the waste ink counter.

You may read the information regarding "end of life" and "waste ink counter" here: http://www.epson.com/cgi-bin/Store/support/InkPadsForm.jsp

To reset the counter, download re-setter program here, install and follow the instruction in the web site.

Good luck and thank you for using FixYa.

Hi, I had the same problem with my RX500.

All you need to do is perform a reset, by pressing and holding the "Stop", "B&W", and "Power" buttons all at the same time and holding them down for at least 10-15secs. It may take a few goes as there's a bit of a nack in getting the buttons pushed at the same time.

Let me know how you get on.

http://www.efillink.com/Support/HowToWasteInkDrainR200.html

I had this problem also. What i did was hold down the 'stop' and the 'B&W' buttons while powering up. this erased the error message and now I am up and running fine again.

Worked for me too!!!
Thank you for the info.. No new printer for me;)

Where are you located? US or UK? if you are in US go to this link so that it will give you the information for that error message

http://www.epson.com/cgi-bin/Store/support/InkPadsForm.jsp

Please read the FAQ then fill forms so that you can Download a utility for it

If helpful, pls dont forget to rate solution. Thanks!!

When turning power on, hold down STOP and B&W buttons together and this should fix error.

there is a program out there that you can download http://www.ssclg.com/epsone.shtml not 100% if it works on your model but worth a try