Konica minolta Bizhub C350. Following message appeared on my printer: Malfunction detected. Please call your Technical Representative and provide code: C-0F36 Please advise. Thank you Michael Fidelis

which model?????

Fan located above the fuser unit the hot part is burned out or very dirty and can not turn

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

did you mean 3451 no 3454 in the service manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

konica minolta bizhub malfunction detected error code c-0200

This is a hard disk error. Time to have a tech come out and replace it.

Hi katienash,

C-0F36 on the bizhub C350 means the machine has registered a really low toner density in the Black
Imaging Unit. I'd take the unit out, give it a shake and pop it back in. Also worth checking you have some Black Toner in it.
Good luck

Regards

m-press.biz

Hi

I have come across this kind of problem.

Is your BizHub on the network? If yes, please switch it off completely, and take the Ethernet cable out of the BizHub.

Wait for atleast 30 seconds and reconnect the cable. Now start the printer again and see if the error message goes away.

Hope this helps!

Code C0F36 is a low toner density error on the black developing unit.

Was it asking for black toner before this code appeared?

This is an indication of a reoccurring error or faulty part. You MUST place a service call.

First power off the printer completely. Then power it back on while holding the UTILITY/COUNTER button. You will see the minolta logo, then you will see a troubleshoot reset button. Press it, you will see an OK result. Power off the printer again, then power it back on without holding the button and everything should work.