Epson says that the printer is malfunctioning and that I should get a new one. The green light is on and neither red light is on. However the printer refuses to print or even print a nozzle check.

The Epson printer won't recognize the ink cartridge when you have dried or empty ink, outdated printer drivers, ink cartridge not installed and much more. You can easily fix the Epson printer not recognize ink cartridge issue with simple steps.





·Remove and Reinstall the ink cartridge

·Check the ink cartridge

·Update printer Drivers



If your Epson printer blinks the Red or green lights, that means your printer has some other technical issue. You can fix the Epson printer lights blinking issue with these methods.

Whatever the fault, just replace it the cost to repair if that is even possible is more than a new model.

The lights continually flashing indicate a paper jam or the printer being out of ink. Check/clear any paper jam and verify the ink cartidge is set correctly.

zark4, The green light flashing means you have print jobs waiting to be printed. Don't Turn Off The Printer When The Green Light Is Flashing ! If you have paper in the printer, the red light means you have an empty ink cartridge. Because both things are happening at the same time, here's what you need to do. First click start. Click printers and faxes. Double left click the Epson C-60 Icon. Left click Printer and click Cancel all documents and click yes, then exit. Remove and reinsert your new ink cartridges to make sure they are seated correctly. After you have done this and the printer finishes the automatic charging of the ink cartridges, the lights should be back to normal. Green light on.

Include the printer. Press and hold the buttons STOP, MANITENANCE ("drop") and POWER whereupon switch off feeding.
http://files.mail.ru/N287AI

-reseat the new cart
-clean the contacts (cart and carriage)
-try a new cart

with regards to the status of the lights., its either the cartridges that you installed is not recognized by the printer's print head or cartridges are defective.
try these steps:
if all the inks are new take them out and get an eraser and rub the small chip gently so as to clean the contacts of the chip ( don't touch it with your finger ) reinsert the cartridges in the printer and allow it to charge.

Only Solution is Re-burn printer firmware.

Mahesh DG, Pune

GET YOUR SOLUTION FROM EPSON

HERE IS YOUR SOLUTION

http://www.epson.com/printer/prob676ijt65/solution



a28

solution service required epson c45