My 805.11g d-link router is working in wirless mode only, i am getting nothing out of all 4 ports?

Connect a LAN cable from Belkin to your laptop/computer'sLAN port, open a browser on your laptop/computer and enter the Belkin'sconfiguration URL. http://192.168.2.1
The default PW = blank (just press Enter) You can now change the default password.
You can now configure the wireless settings. Now configure the wireless card in your computer/laptop withthe router's wireless settings.
To secure your wireless network from unauthorized access,please click on this link and follow my instructions :- http://www.fixya.com/support/r3559128-wireless_router_security

No, is the short answer. It only has the 4 ports which have to be wired with ethernet cables. So this Router is a wired router.

You need to bridge mode your modem. And when set it to bridge mode already. Connect the dlink router. Access the gui of the router. Enter there your username and password. Powercycle modem, router and computer. Check connections. I f this didnt work, set again your modem to default, connect your router. Configure your router with username and password. Powercycle again. Check if it is working.

It sounds like you do not have the proper ports forwarded in your routers configurations.

This link will explain what ones need to be forwarded and how to do it.
http://support.microsoft.com/kb/908874

you can't set teh modem to bridge mode, however, you can set the router to bridge.
The linksys should have bridge mode configuration in the uer guide.

connected the 2 router together
configure the IP address of the liksys to be inthe same subnet as the moem, but out of the range of the DHCP of the modem. ie. DHCP address 192.168.0.2 through 192.169.0.100, the linksys should have the IP address as 192.168.0.200
disable the DHCP on the linksys
setup the wirless just the way you would if ti was the modem.
connect from the modem LAN port to the LAN port on thelinksys. leave the WAN port open.

You should not need the CD for having a PC to access the internet. If you have the manual - Look at accessing the router with http://192.168.0.1

Not sure what you are trying to do... Are you trying have your sister be able to access the internet, through wireless? I'm sure I can help with some more info.

G'luck

To isolate the problem beter connect your wireless router directly to the modem and configure it, check if you are able to go online properly so that you can figure out the problem if your wireless router is not working properly, try upgrading the latest firmware and reset the router and reconfigure the router and that will fix your problem...

Try This link:
http://www.retrevo.com/support/Netgear-WGT624-Wireless-Routers-manual/id/420dj078/t/2/

When you connect your computer directly to your DSL modem with an ethernet cable are you still able to access the internet?

If so we need to see if your DSL modem is assigning IP addresses from the same subnet as your new router.

With your computer connected to your cable modem click Start and then Run (Windows XP) and type "cmd" (no quotes) in the box and hit the enter key. A black window should open. In the window type the following and hit enter "ipconfig /all" Please write down the following items:
1. Description
2. IP Address
3. Default Gateway

Once completed connect your computer to one of the 4 LAN ports on your router, restart your computer and run the same test again then write down the same 3 items.

Please post the information here when complete.

Hi Ashley
Are you trying to hook the router via wireless or via network cable
is the router working with the computer in the living room?
Cheers
petermac181