Doe not run. is there a reset button - Dewalt 4 gal. compressor, 4 hp, gas twin stack tank

call the customer service number listed in your manual that came with unit.

You seem to have inadvertently put it into the test sequence. Try pressing the two reset button simultaneously (usually the reset buttons are 1st and 3rd from left each with a dot underneath, if this does not work, press the button between the two resets (2nd button) P1 should come on then press the right reset button. The unit should run through a test cycle for approx 20mins and eventually reset the module, this is indicated by 0 in the display. Please repost if further assistance required.

Hello,

Which update are you trying to run?
Doing a soft reset on the nuvi will usually get the nuvi up and running.
If there is a reset button on the bottom, press and hold it until the nuvi powers back on. If it does not have the reset button on the bottom, slide and hold the power switch to the left for at least 10 seconds.
Try running the Garmin WebUpdater.
Download and Install WebUpdater.

Hello,

Doing a soft reset on the nuvi will usually get the nuvi up and running.
If there is a reset button on the bottom, press and hold it until the nuvi powers back on. If it does not have the reset button on the bottom, slide and hold the power switch to the left for at least 10 seconds.
Also running the Garmin WebUpdater and reloading the latest update will resolve most issues.
Download and Install WebUpdater.

Soft reset Perform a soft reset
A soft reset stops all running applications, but does not erase any programs or saved data.

NOTE: Be sure to close all running applications before performing a soft reset.

To perform a soft reset:

1. Locate the recessed Reset button on the HP iPAQ.
2. Use the stylus to lightly press the Reset button.

Hard reset
To perform a hard reset and return the HP iPAQ to factory settings:

Press Win + OK + Record together.
While doing that, press reset button and hold for 3-4 seconds.
Release reset.
Release buttons.

NOTE: Do not release the buttons until CLEAN REBOOT appears on the screen.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

there is no reset button on the fuel pump

the dryer was run and just stopped, what's wrong?

have an expert reset it by rewinding it

Do not reset while the motor is running. Reset the CP 3600 when the power is on but with the motor off. OK.

The lock or the thermostat might be damaged, get them replaced.