Model IWL 12 error code 12 - Fisher and Paykel (IWL12)

Error 12 - Indoor unit middle pipe thermistor has disconnected or has shorted out.

https://www.google.com/search?q=LG+LAN120HYV+error+code+12

..

all u nid to do is backup and perform a hardreset.if u cant contact me via my mail iwl show u how

I says power cut restarting in 10 seconds
I'm sorry, it is the board, the switch mode power supply is dying.
Every time it starts to do something it power cuts.
Best to get a new motor controller board,
Quote the 6 digit part number under the bar code to get the right part.

I cannot find your mothers IWL16 model, but I have found various similar machines that are the same phase as your GWL11 machine, the electronics in there although different are compatible, you can swap the drain pumps, there almost universal, avoid the drive shaft machine, fix the other one If you want further help, post a photo of both pcb's (the electronics) After swapping your machine will stil require programming which is simple enough

out of focus.
if all of your discs have the same error code 6, it is optical lens problem. have it checked to the nearest service center.

the[w[ 12 washer has aerror

I have looked at manual for the IWL 16 washer that they have online but cannot locate any fault codes in this booklet. www.fisherpaykel.com may have more information for you or another user may be of more help

The first thing to do is to check if the water valve is good - probably burnt /stuck open.

regards

Had the same problem cleaned the terminals worked for a bit and came back. The problem is that the little circit board that the plug goes onto that sits between the winding of the motor the copper tracks are so small and they corrode. If you are handly with a solding iron you can replace the tracks with small wire, its mainly on one leg of each of the transistors that are all parrelled up. You can tell because it goes black. Or the easy way just take off the motor unpluging the sense plug then the three main power connectors Yellow, blue and red making sure you mark the correct order to put them back on. The sensor board just pulls out of the windings with a little arrow to but it back in the right place and buy the small board it has the part number on it to find it on the web. I only has three bits on it can't be expensive. Soldered mine up works a treat make sur you clean up the plug aswell, it mainly played up in humid weather.