My Photocopier has an error c -6 400

Sharp ARM316 - Error Code: F2-02

PrintCopy .info https://printcopy.info > model=ARM316 > code=F2-02
Code: F2-02; Description: Toner supply failure. The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
Missing: photocopier. ‎' Must include: photocopier.

• 
  

  Sharp ARM355 - Error Code: F2-02

  https://printcopy.info > brand=Sharp > code=F2-02
  Code: F2-02; Description: Toner supply abnormality. Toner control sensor output value becomes under-toner too earlier. Causes: Connector harness trouble ...
  
  Generic video
  
  

See document here:
http://olsonbros.com/sharp/support/pdf_trbl/trbl-ar287_337_407_507.pdf

If you have the install disc , Go into remove programs and uninstall it . then reinstall it . up date as there may be a new driver for it.

Fixing film assembly may need to be replaced if error cannot be cleared. Fixing error codes should be reset by a professional only. Fuser assembly must be examined before resetting the E000, E001, E003 and E007 codes. Enter the service mode this way: Press "Additional Function" key, Press "2" and "8" simultaneously, press "Additional Function" key again. Go to COPIER----FUNCTIONS-----CLEAR----ERR. Here your tech can reset the error codes. Then turn machine off & on again.

Mr Thomas, this code means Fixing error, firsf switch on your Photocopier Machine then press 1,0,8,7 again 1,0,8,7 display will change will show u000. then press 1,6,3 press start key two times. machine will go off and on again. try that ,if will not work i will give you onather way.

How do I clear machine error code E04-01 on a Panasonic DP-3030 photocopier?

Hello sir; I'm not recognize this model number please double check,but I give you closer one to reset;
1, press "program", "interupt", "clear", "interupt".
2, enter 16 press start.
3, turn machine off and back on .

Canon photocopier IR2016J show error code E007. Please advised me on how to resolve

The error code deals with the scaner / mirrors or lamp. When you turn the copier "ON" will the scanning lamp turn on? If not your Lamp is blown or it could be the thermal fuse for the lamp, but it is most likely the lamp. It could also, mean that the Lens is not moving into home position.

That's a fuser error condition...I'll have to get back to you because i have to check in my book to remember how to reset it...Thank you for your patient !