For past 6 Months The scren was bowing Horizontally and now it has sever ghosting.. What to do this TV is about 8 years old Model Number WS-65807

Hello!

Please check the "troubleshooting" of the manual - hope it will help :) http://manualsbrain.com/en/manuals/1136151/?page=25

There are several engine types

1. 3 cylinder
2. Straight 4 cylinder
3. Horizontally opposed 4 cylinder
4. Straight 5 cylinder
5. Straight 6 cylinder
6. Horizontally opposed 6 cylinder
7. V-6
8. V-8
9. V-10

You can find all these engines in various vehicles produced in the last 20 year whether they be gas, diesel, carburated, fuel injected, super charged, or turbo charged.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

That board has been discontinued for several years now. Ebay may be the only place you may still find the Signal board your needing.

PART number for the original remote is :290P10310


Almost any Mitsubishi remote made in the last 8 years will operate this set--even the ones for the DLP type sets--stay away from universal remotes as most of the time the will do only the basic functions---I have talked to customers of mine who found used ones at swap meets etc for very little money---I would bet you can still get the remote from Mitsubishi--if I remember most of these are around 40 dollars from them.

Another idea is have someone at a TV shop look at your old remote--if they know what they are doing they can test it( I have a laminated card with a strip on it--point the remote at the card and the strip should light up when you press any button)

If if cannot be fixed---Try either Mitsubishi or I have seen a lot of these remotes for sale on Ebay.


Let me know if this helps you-----I am here to help people.

SD TECH

It sounds like the coolant leaked from one or more of the projection tubes. You may need to replace the affected tube assemblies.

go to this websight leave an e-mail with your model number and let them know you need a signal board and they should be able to help you plus there prices are very reasonable and they also offer free online tech support to their customers
http://servicemanuals.vstore.ca/

Defective convergence PC board. Must be checked by pro/tech

Try using a DVD though the component input (need a 480P out ). If the pix si ok I wouldsuspect the cable box. If the problem is still there I would suspect a video switching IC or a Leaky regulator.

Temporary fix==solder bad connects STK392-570's. Better yet,replace said convergence IC's. NOTE= Requires r&r of center PCB.Above all else,do no harm......

You need the two convergence IC's replaced part# STK392-570. About a $300-$400 repair.