PF code ,what does it mean ( Calypso washer) - Whirlpool Calypso GVW9959K Top Load Washer

Hello!

Code PF means that a power failure occurred on the control board during the program run.

In most cases, the reason for the code PF on the display is not in the washing machine, but in the problems of electricity supply of your house or apartment.Turning off the electricity or a power surge most often results in this error.

Whirlpool Calypso Washing Machine diagnostics & Error ...

applianceassistant.com/Washer-Repair/Calypso/Calypso-Diagnostics.php

Whirlpool,Calypso,washing machines,repair,troubleshooting,PF,FL,Er,LF,CE,Ld,CA,CI,ob,Sr,LS,SL,error code,problem ... within five seconds while the machine is in Standby Mode. ... The washer does not flash"PF" when it is first plugged in. Press START to continue the cycle from the moment that power was lost -OR-

Washing Machine Fault Codes « Tips, Tricks & Recipes

www.appliancefactoryparts.com/blog/.../washing-machine-fault-codes/

Feb 20, 2010 - Drain pump error, Water level does not decrease to reset point .... If after 30 seconds the control does not detect water entering .... Press START to continue the cycle from the moment that power was lost ... Check pins 1 and 5 of P16 of the machine controller and pins 1 and 2 of P1 of the motor controller.

[PDF]Fault Code Bible v1.2.pdf - ResearchGate

Power Failure.

I had the same problem. The washer control board has an intermittent failure. If you unplug power for about 30 minutes then plug it back in you will get a PF code (power failure). Ignore this code and push start again. It may run till it finishes the cycle or it may start cycling again right away. A new board costs about $180 at repairclinic.com

PF = power failure such as an outage from a storm.  mfg reccomends you unplug for a period of time.  i would suggest about 15 minutes.  then try it again

PF Power failure "PF" flashes if the washer loses power during a running cycle. The washer does not flash "PF" when it is first plugged in.

Press START to continue the cycle from the moment that power was lost.

OR

Press STOP/CANCEL to clear the display and completely cancel the cycle.

Pf is power failure code you must push clear or reset washer by unplugging and plugging back in Good luck

PF means Power Failure!
Unplug both units for 10 minutes, then plug them back in and try operating them. You may need an electrician to investigate why you are losing power to both units

found a pf not an a fp


PF Power Failure PF flashes if the washer loses power during a running cycle. The washer does not flash PF when it is first plugged in.

Press START to continue the cycle from the moment that power was lost -OR-

Press STOP/CANCEL to clear the display and completely cancel the cycle.

THIS is a "Power Failure " Clease the code (press Cancel button) and see if it starts up