Bosch maxx clasic front loader Wkm41 the control panel has just died. what can I do to fix this?

It is a good machine and still has life. The most likely cause is loose or broken damper springs. You would need to remove the top to check. If it feels loose at the back, (the front of the drum moves up and down), it is likely the rear bearing.

https://www.google.com/search?q=Bosch+wkm41+parts

..

http://laundry.manualsonline.com/manuals/mfg/bosch/800_series.html . That should be the manual for the bosch wkm41. If not get back to me and i'll take another look. Also the bosch website has manuals searched by serial number if you get too stuck.

please see the next step:
1) turn off the machine, and inspect the water connections
2)This error occurs if the appliance does not take in water or does not do so correctly. Make sure the water intake tap is turned on.3) Refer you instruction manual for aditional idea. if you do not have download from www. retrevo.com or from Bosch.
God bless you

Hello, W/D here.

Remove the tray, and clean the tubes on the bottom side of the dispensers and the mating tubes on the machine. This should put you right.

Best regards, --W/D--

If you rotate the pulley on the back of the drum does it rotate the drum? i have seen these snap the back of the drum off. also they can have issues with the controller board for the motors which would require a technician to determine.

This video will show you how to change a door seal on this Bosch front loader washing machine
we have all bosch repairs in our channel

To change the seal the easiest way is to take the front of the appliance off. Remove the kick plate at bottom and you will see some screws holding the front panel on remove these Then open door and remove the screws holding the door lock on and unlip the seal by releasing the clamp on the front. The front should now lift off, if it doesnt then pull out the soap drawer and behind that at the bottom of the drawer is a screw holding the front on remove this then push the front panel down then it will lift off You can now take the clamp holding the seal to the tub off. Fit the new seal, fit the clamp to the seal and tub. From here, rebuilding is the reverse of the strip down.

There are a couple of sites you can try.

WWW.ESPARES.CO.UK/BOSCH

WWW.4BOSCH.CO.UK/SPARES

Please rate my solution.
Thankyou

This will require a replacement door lock,easy replacement & part very cheap

Is it water in the tub that you can see?