If I reset my J/VC will I lose all video - JVC Everio GZ-MG21 Camcorder

Either take it into a cell phone provider location or perform a factory reset on it, you will lose all your data that is on it.

You have to press the clear button on your remote control to put the counter to zero.

Here are some websites which can supply a manual for the Sharp VCR vc-h997u: http://www.diagram.com.ua/english/catalog/eng-w-video/s/eng-w-video-s.php?row=1338
https://www.samswebsite.com/en/photofact/details/index/id/204436
http://www.user-manuals.com/advanced_search_result.php?keywords=vch997u
Beware of free services. They can be ok, but just be cautious.

The VC code on a sharp mx-2700 is the cyan developer has reached its maintenance cycle of 60,000 copies. to clear this code enter sim mode #, *, C, * then 24-5 to clear dv count.

Free PDF Manual can be downloaded from the link below.

http://www.nodevice.com/user_manual/sharp/video_recorder/vc-a565uh965u/download.html

Hey Friends .............Few days back i faced the same problem...when i play vc its showed me VC cannot find available video meomary." ..i was so worried because i had good processor 3.40Ghz with 1gb ram and 100GB hard...........and then i checked The properties of My computer and visited the Device Manager ...i could find the yellow sign on graphics and video card ..it meant that i hadnt installed the proper drivers.........After installing all that drivers ...now i m able to play vc with high speed and fun....thankzzz.....for contact [email protected]

your vc might be heating up, try to remove it agai. take the heatsink out and then put a thermal paste on it before returning it on the vc, then install it again and see if that will works.

IF YOU ARE SHARING THIS DEVICE WITH ANY OTHER DEVICE YOU WILL CONTINUE HAVE THESE PROBLEMS OR BURNING THAT DEVICE CONTROL ON THE MOTHER BOARD. YOU MAY HAVE TO DISABLE IT I DEVICE MANAGER OR UNINSTALL IT.

YOOU MITE EVEN CORRUPTED THE BOOT SECTOR ON THE DRIVE AND LOOSE EVERYTHING ON THE DRIVE

ROD

Reset your modem.
There is a reset button on the back.
Push it in and hold it down for thirty seconds with the modem on.
Log into the modem at 192.168.1.1 (admin/password=username/password)
You will need to change the modems administration username/password, doesn't matter what to since we'll make it unreachable soon enough.
On the connection overview page goto configuration.
Go to DHCP configuration and switch the DHCP server off.
Then goto configuration and click on VC configuration.
All but the first VC should be disabled.
Click on the edit or configure button next to the first and enabled VC.
Switch from either DHCP or PPPoE to Bridge.
At the bottom of the screen click on set VC.
Done.
Your modem is now in 'full bridge' mode and will need to be reset again to get it out.

DO you realize that this camera cost around 900 US$? - Might be a little overkill for VOIP.
Apart form that it is an excellent camera. Have look at the manual here.
The camera connects via RS232 (9DSub) or 8pin DSub and you can/have to download the software form Canon's web page.