My samsung vrt front loader will not drain or spin and showing nd code

top loader or front loader is the data missing

as far as I am aware the ND code means not draining would check your drain hose pipe or the filter could be blocked causing it not to drain properly while spinning

There is no filter on a top loader. You water pump may be clogged with a sock or it may have failed.

This video will help you diagnose the fault on Samsung Vrt steam 3e error codes and the video will help you solve the problem

And code fans no drain you have to unclog your pump. Depending on your model access is in lower front or in the rear. Pull out your washer unfortunately you will have to unbail it. If pump clean out access is in lower front turn the filter head counter clock wise and clear any debris.rear access remove to hose it should be held in place with two 7/16 the nuts remove and clear debris if that doesn't clear code it may have clogged again with excess debis clear again good luck! Howevver may need to replace the pump

ND is not draining, the washer probably has water in it and won't open. In which case you need to open the little tiny panel on the front of the washer and pull out the little hose and drain the washer and then clean our the filter next to the hose. NB means not balanced and the clothes have become unbalanced, move the clothes around and start it back up. If it happens a lot the washer is not on even ground and needs to be leveled.

Sounds like your drain is plugged. Your drain hose has debris in it and you need to get at the drain pump hoses and clean them out

on my kenmore machine nd means the drain filter is clogged. open the cover, drain water completely, remove and clean the filter, replace filter, tighten and close cover. hope this works for you. if not , at least your drain filter will be cleaned and you can eliminate it as the problem.

Yes ! this is related to fabric and hair accumulation and so it will be best to check the drain filter when you experience this issue.

this is a no drain error or slow drain issue you need to check for anything that would or is restricting the water from draining out of the tub.
if the water will not srin then you can use a wet dry shop vac and attach it to the end of the drain hose to remove the water.
then check all your hose to and from the drain pump