How do i install the cd-rom on a mac - D-Link DCS-950G Network Camera

Copy the CD Rom files to a large thumb drive. Setup and install the programs from there. If that does not work, contact Verbatim customer support: http://www.verbatim.com/contact-us/

Make sure you have installed the MAC drivers correctly from the CD-ROM. Connect the cables and leave the printer "OFF." Then insert the CD-ROM into the PC and follow the installation instructions to the letter. Reboot the computer and try it out. Also, go to the Canon support site to see if there are updated MAC drivers and software for this model. Install the updated drivers and then any software that came with the installation CD-Rom.

If you cannot install the driver on Mac OS X 10.7 - 10.9 from the CD-ROM, go to the Downloads section of this website to install the latest drivers. Click the link below to go to theDownloadssection: Download Brother Printer Drivers 1 855 383 7237 Tech Support Printer

http://www.usa.canon.com/consumer/controller;topic=609.msg7369?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=104&modelid=6624#DownloadDetailAct




Mac OS X (Native Mode)

1. Turn the computer on. Log in as the first created administrator account to install the software. You cannot install the software when logged in using added administrator accounts.
   
2. Place the CanoScan Setup Utility CD-ROM in the drive.
   
3. Double-click the CD-ROM icon.
   
4. Double-click the MacOS X folder/icon.
   
5. Note: Some versions of the CanoScan Setup CD-ROM will not include the Mac OS X version of Toolbox. If this is the case, you should download and install Toolbox from Canon's website. www.canontechsupport.com
   If you will not be installing Toolbox at this time, skip to step 7.
   
   Double-click the CanoScan Toolbox folder/icon.
   
6. Double-click the CanoScan Toolbox Installer icon. Follow the on-screen prompts to complete the installation.
   
7. Once the installation of Toolbox is complete, you should then access the ScanGear CS folder also located in the MacOS X folder.
   
8. From the ScanGear CS folder, click the ScanGear CS Installer icon. The installer will search for available install locations for the scanner plug-in driver. Follow the on-screen message prompts to complete the installation.

Install Nero ver. 8 or 9 and all licenses.. you can download it for free in bitcomet or any torrent sites. good luck

Use Ultra ISO or other VCD-ROM to mount the cd iso image on your hdd and map it in VMware F

Just follow the link and click on Printer Driver Vers 7.0.1 for Mac OS X or the MAC OS X CUPS printer driver version 10.2.2.0 and you should be up and running.
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=257&modelid=16278#DownloadDetailAct

for you to use this machine on a MAC you need a PCL board installed in your machine.

Since Macs are not compatible with 3' cd's the only way it could work is if you had an external cd drive. You can even get them cheap! Here is a link to one on a website. I never used this website to purchase anything but its just to show you what you might consider looking for!
http://tekgems.com/Products/tg-et-20875-cdr-blk-24xext-cdr.htm

I personally hate how macs are not compatible with 3 inch cds but I hope this helps you out and good luck!

these are the drivers and support for the MAC.... http://www.lacie.com/support/drivers/index.htm?id=10011 I hope this helps if not email me at troublerst at hotmail and I will see what else i can do