Problem for Sharp AR-5320 Black and White Copier Ar 5516 display H4 error?

http://www.sharpmea.com/cps/rde/xbcr/documents/documents/om/34_ppc/AR5516-D-5520-D_OM_GB.pdf

Toner chip problem.You should replace the chip.

H4 00 Heat roller low temperature detection

Hello :

It's a bad component in the fuse. It could be a bad thermofuse or thermistor . Better to take it to a Sharp dealer . They should be able to repair it right and quickly .

good luck .

please don't forget to rate !

H means heat, you need a new fuser.

This means that the fusing unit has a problem. Turn off the copier. Open the small side cover on the right of the fuser unit. You will see the wire connectors leading from the unit and carefully remove them.Open the three screws holding the unit and remove it, check the heater lamp continuity if out replace the lamp. Clean the thermistor and return the unit by reversing the removing process. Now try the code and it will work.

During installation , use sharp ar205 developer and sharp ar021 toner cartridge. This shows you did not use developer or used the wrong ones, good luck.

There is no such error 'E215-0000' in ar 5320, for H4 use "#, Interrupt, C, interrupt. Display goes off, Enter 14, Press Print key.

it is on you fusing unit of your copier, check the fuse maybe it is open already and need for replacement... H4 means that your heater lamp is not functioning


franklin

Sharp AR -5320 Software Download