Pairing code for Microsoft Wireless Laser Mouse 5000

SOURCE: microsoft wireless laser mouse 5000

If you are using Vista Operating System this is a common problem.
!. Go to MY COMPUTER and RIGHT CLICK on it. 2. Then CLICK on PROPERTIES.
3. Next CLICK on DEVICE MANAGER.
4.Next CLICK on CONTINUE.
5. CLICK on the HID HUMAN INTERFACE DEVICE +.
6.Right CLICK on the HID NON-USER INPUT DATA FILTER.
7. Click on UPDATE DRIVER SOFTWARE.
8. When the screen comes up CLICK on SEARCH AUTOMATICALLY for UPDATED DRIVER SOFTWARE.

When finished the screen saver should work properly. Bud

SOURCE: why does not microsoft wireless mouse laser 6000 work suddenly?

Well, I had the same problem, too, and I just turned my PC off, waited a few seconds and turned it on again. This means I really turned it off completely; normal restarting didn't work. Maybe that helps you too. 

Erick Steelman

• 15 Answers
• Posted on Dec 20, 2009

SOURCE: the wireless mouse works but the laser 5000

press connect on the wireless device...let go and then within 5 seconds press the button on the bottom of the keyboard. Repeat the same steps for the mouse whther its working or not. The problem usually is that the keyboard and mouse are on the same "Wireless Channel" and only resyncing them puts them on a seperate channel, hope this helps.
Erick

SOURCE: I have a Microsoft Wireless Desktop Receiver 3.1

I have the same system. Mouse can be ordered, but not easily. Make sure mouse is not working.... i almost made tour same mistake. In my case, the mouse plug (from computer to wireless receiver) had become unhooked. All i could see is that mouse was communicating with wireless receiver but appeared to be frozen. If you can reset receiving channel, and see that receiver acknowledges presence of mouse, you may have my same problem. Also, if you can see that the laser light is working, mouse is probably ok, and batteries are good.