TV won't turn on

Try a new lamp part# BP96-01472A
http://www.shopjimmy.com/dlplamps?tv_brands_select=Samsung&tv_models=Samsung+HLS6167WX%2FXAA

plug in a bed side light and see is it working and if it is not then the storm has damaged the tramsformer supplying your house

Hello
Setup code for Sony TV with Vizio Universal remote control is [ 0000 ]

The reomote control is pre-programmed to work with all esisting Vizio TVs. If you want to set up it with Sony TV, do the following.
1. Manualy turn on the TV.
2. Press the [TV2] button on the remote control.
3. Press and Hold the Setup button until the LED light flashes twice.
4. Enter (0000) using the number buttons. If the code is accepted the LED flashes twice after the last digit is entered. If the LED does not flash, repeat steps 2 through 4 once again.
5. Point the remote control at the tV and press POWER button. The TV will turn OFF.

Other four digit codes to check for Sony TVs are: 0128/0013/0002/0071 & 0380.
If code [0000] does not respond with try other codes. Repeatsteps 2 through 4 once again after entering each code listed. The code listed with Vizio universal remote control with Sony TV is [ 0000 ].
OK.

lrsnihe

You were attempting to perform a power scan initially. The second procedure is manually attempting to address the remote to your TV. I will give you the procedures again so you can try one more time. Emerson TV is one brand we have a low percentage of success getting our remotes to work. If it still doesn't work, we could try replacing the remote.

TV code: 623, 667, 666, 233, 516, 537, 544, 642, 655, 699, 000, 999, 888, and 720.

Remotes: Basic (Television Only)

1. Turn the Television On.
2. Press and hold the clear TV button for six seconds until the LED flashes.
3. Enter the three-digit code using the buttons on the number pad.
4. Press #. Note: The LED will flash three times.
5. Test functionality with the TV.
6. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television.

Remote Power Scan: Basic Remote (Television Only)

1. Turn the Television On.
2. Press and hold the clear TV button for six seconds until the LED flashes.
3. Press and release the red TV Power button.
4. Press and release the Up or Down Arrow on the remote until the television turns off once every second.
5. After the television turns off, press and release the # button.
6. Test functionality with the TV.
7. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television.

The tv "LAMP"LED light indication flashes or stay lit?The tv projection lamp been in this tv like 1/2 or 2 years?Tv been on and used like 4 or 5 hours a day?Yes,than the tv projection lamp life are over.Require a new tv projection lamp.

Color Wheel - Pull out the Lamp using a flash light look right into where Lamp was you should see the color wheel turn TV on watch to see if wheel is turning,From what you have said Problem will be the Color Wheel. Encompass Parts Distribution has them 1-800-638-3328

Sounds that tv got color wheel problem that will be replaced.
If you are handy with electronics stuff repair then replace color wheel in light engine of tv to solve its issue.

3 lights on front flashing indicates lamp quit. Could be lamp or ballast.

replace lamp found behind cover on back or side of tv

Yes, Turn On TV, press and hold Volume Down button on TV front and Split button on remote at same time for 6 seconds to reset lamp timer in TV.