Paslode f16 im65 has stopped working and flashing red and green in the gun, what could b the problem?

The Paslode gun can flash green and red due to several reasons; it includes:

1. Either your co2 is empty, or your battery is dead.
2. The pasload may have a bad cooling fan.

Can denotes the motor has gone

hi it could be your gun if it is flashing red&green this means theres a fault with the gun if it is just red try cleaning the battery treminals with a bit of sand paper some times they get a bit dirty and dont get enough contact with the gun hope this helps

Replacement Paslode IM350 Cordless Drill Battery

• Type: Ni-MH
• Volt: 6V
• Capacity: 3000mAh
• Color: Black
• Weight: 309.25g
• Dimension: 134.60 x49.40 x28.10mm

http://www.drillbattery.com.au/buybattery.php/paslode_IM350_power+tool+battery.html

Hi,
You need to use the correct nails...

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

,./,./';';

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

]

most new nail guns and stapler don't call for oil.check your gun to make sure that it needs oil . in my experience oiling a gun that doesn't call for it will cause more trouble .if this is the case you will need to get the oil out of it. you can try spraying contact cleaner in the air intake and hooking the air line up and firing the gun.if this wont fix it you may need to pull it apart to clean the oil out.be careful what you use to clean this with because you can cause your O-Rings in your gun to swell up.any nick in a O-Ring can cause failure. i hope this helps you out

go to Paslode.com and you can download the manual for free. Let me know if you have any problems

sounds like the pasload you have may have a bad cooling fan.