When i write hhtp://dlinkap on the explorer internet i have nothing

in order to access 192.168.0.50, your computer needs to have an IP from 192.168.0.1 to 192.168.0.49 or 192.168.0.51 to 192.168.0.254. Assuming a default subnet mask of 255.255.255.0
In other words, if the IP of your computer is 192.168.1.10, you will not be able (under typical conditions) to reach 192.168.0.50

http://support.dlink.com/emulators/wbr2310/lan.htm

are you using internet explorer, or what kind of browser.

you should be able to type in http://192.168.9.50 in the web address window. as long as the pc your on can see the router on the network.

most routers have the default address of 192.168.1.1 try typing that instead of the above number in the web address box.

Bill K

Hi,

The error you are getting, HTTP Error: 502 Bad Gateway, is not a problem that you are able to fix.

The error relates to one of two things:

1) The site you are trying to access has a problem with it's server and you will get the same error message from any device that trys to access the site.

2) Your network carrier is experiencing network difficulties/equipment failure and needs to repair the fault.

The error may already have been resolved. To check this, restart your phone to clear the cache and try to access the internet again.

Regards,
sjstore2

If you are trying to connect to the routers web interface via wireless, you will not be able to do so without the key. Connect to the router via eternet cable. Then, you will be able to connect to 192.168.2.1

The DLink URL WEB configuration uses an IP address not //dlinkap
Try http://192.168.0.1
The default ligin = admin
The default PW = blank ie. nothing

You cannot configure the DLink by the URL address http://dlinkap?
You connect a LAN cable from your computer to the DLink.
Then open Internet Explorer and enter the URL http://192.168.0.1
the default login = admin
the PW is blank (just press Enter)
You can now configure the DLink.

Tools>Internet Otions> Delete button
Select All and click Delete.

To change the password, you might need to plug in your ethernet able to your computer and then your router. Then try 192.168.0.1 to again connect to router.
If you are using wireless the password of the router doesn't need to change. You will though need to set your new modem to be ale to connect to your network.