WE HAVE A RANGEMASTER AMERICAN STYLE FRIDGE FREEZER. THE WATER DISPENSER LIGHT HAS STARTED TO GLOW RED AND HAS ALWAYS BEEN BLUE. NOTHING IN THE MANUAL ABOUT THIS. the water still flows normally and other than the colour of the light its ok??

It almost certainly needs a new thermistor, which is the electronic thermostat sensor.

Hi,

the water should be dispensed on a regular schedule just based on the basic programming within the fridge. Please lower the temperature of the fridge in order to check if the water can flow into the freezer as the only thing I could think of it that it somehow froze on the way in.

Thank you.

its the compresor packed up,,,if this compresor is not pumping freezer gas around the pipe work the freezer wont work sorry but a new compresor is not a cheep thing to have fitted as it will need a re-gas as well

there is a defrost mode that melts any frost or ice on the evaporator coils and drains it into a pan under the fridge. if that drain is blocked, the water will pool inside. also check the door seals. if warm moist air leaks in, it'll condense on the cold interior and pool as well.

You can use a hairdryer on the frozen parts.
The fridge gets its cold air from the freezer through a vent(damper) between the freezer and fridge.The fan in the freezer blows air through it. There is a flap you adjust with the fridge temp. control. Make sure it's opening and closing when you adjust the fridge temp ..

Sounds like the water hose to the ice maker has come loose. Is it in warranty?

call for factory service

verify on the back side of fridge sometimes you will see the water lines if not there's like a a cover that goes vertically if removed, probably you'll have access to water line its probably plugged up...


or sometimes air gets trapped in the supply line to purge just simply loosen the nut or fitting it should spit some water do this just enough to let air out about after 30 sec. if there was some air in the water line i should start to spit water...

hope i could be of help

Spray a good quantity of WD-40 on the spindle of the fan motor where it enters the motor itself. This should get the fan working smoothly with no noise. This will probably solve the other problems, as the fan prevents various components from overheating and shutting down.

make sure your fan is running in freezer section. you should hear it