My husqvarna yth2348 hydorstatic transmission seems to be slipping. Is there an adjustment or something i can do?
Check your tensioning bracket, when parked and engine off, lower the deck, look underneath from the left hand brake pedal side and work the brake pedal by hand take notice of the bracket with two pulleys mounted on it that move with the brake pedal being pressed and depressed, if you have vertical? up and down movement opposed to horizontal fwd and back movement your bracket mount and or bushing could be worn out.. Mine was, and after replacement it was like the day I bought it new.
Hope you his helps..
SOURCE: I NEED BELT DIAGRAM FOR MY HUSQVARNA RIDING MOWER
http://www.usa.husqvarna.com/home.aspx try this out for your answers, I hope this helps you. MERRY CHRISTMAS!
SOURCE: Where is the oil filter located on the Husqvarna
if its a 23 hp briggs and stratton it should be on the opposite side from the dipstick where you check the oil down low.
It may be black with a briggs and stratton label or it may be yellow with the same.
SOURCE: just purchased Husqvarna YTH2348 Purged
As for whining sound I believe this normal. The purging instruction using the bypass valve ingaged on low engine running. Next with the bypass disengaged followed by the fwd with fast breaking and or rev with fast breaking actions to get the wheels to turning and getting better responce takes time. This does take some time to do - in my case 15 minutes or more. My tractor had 65 hours on it before it showed signs of not pulling a slight hill. I had to remove the transaxle and put in 50 wt. motor oil and with the purging I was able to bring new life back to this tractor. The original 30wt. motor oil is fine for a brake in oil and I did drain it and took the bottom cover pan off and cleaned the metal particals on the magnets and cleaned the filter. These transaxle are sealed but have a vent plug at the top of the case. That little plug is hard to get off with out damaging it. My tractor whins in forward and reverse but has good hydrostatic power now. So I say the whin is good!
SOURCE: Husqvarna YTH2348 drive belt slipping
Is there the proper amount of tension on the belt?Look in your owner's manual to find out how to adjust the tension.
SOURCE: husqvarna yth2348 keeps blowing fuses as soon as
You have a dead short in the circuit for that fuse. Check for a pinched wire, or a wire rubbed thru a touching metal.
Testimonial: "very helpful with the problem"
4,251 views
Usually answered in minutes!
×