During use, the speed goes to zero on the panel and then a couple minutes later, it shuts off....Schwinn 430 elliptical.

Schwinn® 430 and Journey 4.0 Elliptical Fitness ... - Nautilus

download.nautilus.com > SCH.430.SM.EN.pdf

PDF Roller Wheel Disc (older models only). 48. 15 ... change between "BIKE" and Elliptical ("ELIP"). 9. ... Replace the Brake Assembly on the Schwinn® 430/470.

assembly manual / owner's manual - Nautilus

download.nautilus.com > AM_OM > Schwinn > SCH.4...

PDF Manual en Espa?ol Latino Americano: http://www.schwinnfitness.com. 430 / ... If replacement parts are necessary, use only genuine Nautilus replacement parts and ... PEDAL TO CONTINUE (if a bike) / STRIDE TO CONTINUE (if an elliptical).

Replacing The Console Batteries - Schwinn a40 Owner's ...

www.manualslib.com > ... > Owner's manual

The Machine Type switch (N) on the Console is preset at the factory to B (bike) or E (elliptical). If you replace the console,. it will possibly be necessary to set the ...

How to Replace an Elliptical Console - YouTube

www.youtube.com > watch
0:42 This video from Sears PartsDirect shows how to replace a console on an elliptical. ... Precor EFX 546 ... May 22, 2015 · Uploaded by Sears PartsDirect

Do you think the power cord is going bad? If so here is the parts list for the Schwinn 430 if you need to order a new AC adaptor. If you think the connection inside the machine is going bad you may want to find a servicer to look at it.

Here is a link for the manual you need. Please rate me.

http://download.dfxi.com/supportdocs/OM/Schwinn/SCH_430_OM_RevA_web.pdf

I took a magnet from a magnetix toy and secured it to the correct side of the flywheel. It's working now...I just finshed doing it. Hopefully it'll continue working. Thanks for pointing out the magnet was on the wrong side.

It should be at the bottom of the machine in the front facing away from you if you are on it.

To install new AA batteries just pop the battery door in the back of the computer

need assembly instructions for a schwinn airdyne

I have this same problem and called the customer service. The problem is that the rpm sensor is not working. It could be the sensor or something else. They had me check the connections first for the wiring harness at the top and middle and then sent me parts to work on the inside where I have my problem. I am still working on mine because the magnet was installed on the wrong side of the flywheel. Hope you don't have this issue.

http://download.dfxi.com/supportdocs/SM/Schwinn/SCH_430_431_450_SM_RevC_web.pdf
Follow this link for step by step instructions. Note you will need a crank puller which you can purchase at most bike shops. remove both covers then crank weldment(discs).

Hi I'm Ryan, do you know where it is squeeking from? if you can find the squeek try 3 in 1 oil that should stop it.