Whirlpool self cleaning oven problem

It's best to remove the racks. However you can go on line to download a free manual.

http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Whirlpool Range / Stove / Oven Fault Codes

this website gives the problem code what it means and the soulution
It may help you

I researched your question regarding error code FSE1. I could not find a response regarding a self cleaning oven. If you will provide the model number on the below listed website under "cooking" you may get a detailed response.
http://producthelp.whirlpool.com

It seems that a general "fix" for error codes is to got to your electrical panel and shut off the breaker controlling your device for 1 minute. This resets the device and will reset the error code. (May not fix your issue but will reset code.)

Your manual should have a list of error codes to help you resolve this issue. If you have misplaced the manual, you can also download one for your device from Whirlpool's website as well.

If all else fails here are the U.S. and Canadian telephone numbers under "Contact us". I do not know if this is a pay line or Whirlpool will answer your questions and attempt to resolve at no cost.

US: 1-866-698-2538
Canada: 1-800-807-6777

Hi,

Before you go working too hard to get you oven to go into the self clean mode(self destruct)....check out this tip...

Self Cleaning Oven Problem


heatman101

The most likely part to be the prob is gonna be the ignitor. Even if it is glowing it could be weak. If it is dim orange it is weak. Check out this Vid:


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

HI. This code is a good indication of a separated key pad ribbon or the actual key pad may be damaged. Use the procedure below to isolate the culprit.

1. Check keypad connector for firm connection (keypad connects to control board).
2. Press CANCEL. If error code returns after 60 seconds, replace keypad (also called touch pad or membrane switch). Some models incorporate keypad in to control board as one unit. In this case, replace control board (also called ERC or clock).

Hi,
Check out this tip that I wrote about this problem...

http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating

heatman101

Hello. It is possible that the oven accidentally got turned to the self-clean function. Check to see. If it is set to self-clean, the door lock activated. In order to unlock the oven has to be taken off of self-clean and then it has to cool down to room temperature before it will unlock. Joe

HOW DO YOU CLEAN SELF CLEANING OVEN SUPER CAPICITY 465