Do indesit dishwashers have a reset button? If so where is it located on the dishwasher? As ours just stopped working for no apparent reason yet the power light still shows up but when you push any of the 4 cycle buttons nothing happens?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try cutting the power to the dishwasher (remove the fuse) for about 30 seconds, then when you put the fuse back in, do it quickly and smoothly so you get a clean power-on without a lot of sparking. This may get the dishwasher controller to do a proper hard power-on reset.
If the problem persists, you may have a hardware failure in the controller. The first thing I'd look for is a failing electrolytic capacitor. Sometimes a power on-off cycle finishes them off. Fortunately, the parts are cheap and readily available from online suppliers such as Digi-Key or Mouser. Unfortunately, you have to have electronic component soldering skills to change them. Often, bad capacitors can be visually identified because the top of the capacitor is domed instead of flat, or for smaller units the aluminum casing is partly pushed off of the rubber or plastic base.
Contrast the bad capacitor on the right with the good one next to it on the left.
Switch off the appliance by pressing the O N/OFF button. Shut off
the water tap to eliminate the risk of flooding and remove the plug
from the electrical socket.
Make sure the water inlet filter has not become blocked by various impurities. (see "Care and maintenance" chapter)
no, turn the on / off button off, then turn off the power for about 5 minutes and then it should work again. and at some point do contact someone to look at it.
have no access to manual. but you could... try to recycle the power. shut off breaker or unplug for a minute or two. then turn back on. it may reset. good luck mark
indesit idl 40 not pumping water out properly, ends with flashing light no 4 and plates dry but water still in machine -have to pump out using start stop button but within 2 hours base filled up with water. Can't afford massive call out prices as lady on my own.....
i have similar problem machine starts then stops while bleeping the second and third lights then flash nothing more happens have checked water intake which is ok no blockages any more ideas would help thanks
Having read another users fault (LUNNY) that has same fault. They got engr out and it was a blocked pump. Where is the pupmp located on this model as I have the same fault and want to resolve it asap.
×