Hi..
You can find the driver here
Download & Install
http://www.dlink.com.au/tech/Download/download.aspx?product=DIR-300
Good LucK:-)
First coonect your wifi router witjh your laptop with ether net then go to this link
http://192.168.0.1
then type user :admin and password also admin or blank
then go to dhcp then enbale it with auto .
then disconnect your cable from laptop.
then go to my network places then find wireless network then simply conect your network.
thats it.
SOURCE: VPN problem with Dlink DIR-300
Update your firmware to the latest. I had the same issue and the issue is gone after the upgrade.
SOURCE: i have activated the nat mode of my dlink dir-300
check the IP of your computer by going to dos: Run -> CMS -> then type IPCONFIG. If your IP address is not in the 192.168.0.X range then you will not be able to access it. You may have the IP assigned by the ISP or you may have to renew the ip address by restarting your computer. You can use another computer see if gets the 192... range or assign an IP belonging to that range manually.
SOURCE: how to put a password on dlink dir-300 wireless network
u have to setup as wep
then enable secure network then set encryption key.wihc is prompt for connect network.
344 views
Usually answered in minutes!
×