Polaroid FCM-1000A 10 in. LCD under counter tv I replaced the battery in the remote--still doesn't work, any suggestions?

sir i want the service code of beltek colour tv

Hi.

Please test the TV using a programmable remote. If the TV works using the programmable remote buy a replacement remote control:

NEW POLAROID REMOTE CONTROL TDA-03211C TDX-01930B

Polaroid TDX01930B Replacement Remote Control

Polaroid Remote Controls

my remote control will not work after changing the battery on POLAROID ORIGINAL LCD FLU-2632 TV REMOTE CONTROL please help

http://www.fixya.com/support/t626824-polaroid_fdm_0700a

check the user manual also can be misconfigured or check the video input and the same display

Get a new remote or try it again with new batteries.

The battery is probably not the only problem. If the display won't lite it is either the inverter board or the back lites

1) Use 2 new AA batteries in RC32 remote control;
2) Slide mode switch to "TV";
3) Press and hold the MUTE and SELECT keys at the same
time until the green light under the selected switch
position flashes twice, then release both keys.
4) Enter 9-9-1-1.
5) Press PWR button on TV.
6) Point the remote at the TV and press CHAN+. Repeatedly press CHAN+ until the TV turns off. Every time CHAN+ is pressed the remote advances to the next code and power is transmitted to the component.
7) Use the CHAN- key to step back a code.
8) When the TV turns off, stop pressing the CHAN+ key. Then, press and release the SELECT key. If the light flashes 3 times before the TV or component responds, you've cycled through all codes and the code you need is not available. You must use the TV remote control.
9) To verify the code, slide the MODE switch to the appropriate position.
10) Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch position flashes twice, then release both keys.
11) Enter 9-9-0. (The green light under the selected
switch position flashes twice.)
12) To view the first digit in the code, Press and release then number 1 key. Wait three seconds, and count the number of times the green light flashes. Write this number down in the TV owner manual.
13) Press number 2 for the second digit, 3 for the third digit, 4 for the fourth digit and 5 for the final digit.

To control TV volume from Directv RC32:
1. Press and hold the MUTE and SELECT keys until the
green light under the DIRECTV position flashes twice,
then release both keys.
2. Using the number keys, enter 9-9-3. (The green light
will flash twice after the 3.)
3. Press and release the VOL+ key. (The green light
flashes 4 times.)

buy a new after all their not that expensive

It is a known defect that polaroid won't stand behind!  The original part which I suggest not to but b/c it will just burn up again is UI8007S-1...I highly suggest buying an upgraded part from www.lcdparts.net which is UI8007S-1MSS, and actually less expensive than the worthless original.
I will never purchase a Polaroid product again!!!!


http://www.mp3car.com/vbulletin/lcd-display/74566-backlight-inverter.html