The toshiba p205 froze. when I sitch it of and turn it back on I do not get the usual 3 option opening screen, but the same frozen screen. Nothing work, programs and I cannot access any recovery program. What should I do?

same here ! solution??? screen has the ENTER PIN FOR BLUETOOTH frozen and floating over the usual touch
screen/icons

QUICK SOLUTION IS

the os with the correct disks 2. Ensure the correct drivers are used 3.request the correct installation disks from the PC manufacturer 4. The blue screen will no longer be an issue as you should not see it anymore
LONG SOLUTION
TRY AN EXTERNAL MONITOR TO SEE IF YOUR MONITOR IS THE PROBLEM. IF IT IS, BE PREPARED TO PAY OUT $125 PLUS FOR A NEW ONE

There are a lot of things that can cause this.
But the one that is in your grasp is a problem with the Memory Modules.
Open the small cover on the bottom that covers the memory.
Remove one chip leaving one chip, and rotate between the slots and the modules.
A bad ram chip will cause this problem.
Lets hope thats what it is, because otherwise it could very well be a problem with the motherboard, and that is not too cost effective to repair/replace.

Your system is consuming much power.

Go to Control Panel, Power Options.

Click "Advanced Power Settings" for your current power plan.

Under the section "What happens when I close the lid", choose "Do nothing" for both "Battery" and "Plugged-in".

Click "Apply" and "Ok".

Now, close the lid of your laptop and open it, it would restore but next time don't overload your system power.

This is common with Dell and Toshiba.

i think there is some issues with the OS because i noticed you can't shut it down properly so maybe the files needed in order to shut down had been corrupted but one more theory, the bios settings make sure that everythings configured properly there by checking the power options on the bios setup(the blue screen)so try setting it to default and change the boot priority to HDD,CDROM,FLOPPY.

You can only run 2gig max IE: 2- 1gig or 1-2gig you cant run 2-2gig the bios will not accept it

hi,
try this one
take out the battery and take out the Ac adapter now press and hold the power button for 15 sec this will release any static charge residing in your laptop.

now try start your laptop with battery in.

Further Queries are welcome

I want you to restart and then pressing F8 while in restart try to get into LAST KNOWN GOOD
if it won't boot that when then restart again pressing F8 then start in SAFEMODE
While in safemode open control panel and then users
click on your user name and make sure your settings are still there
close off user and open display click screensaver then power and make sure your settings there are correct change stanby to never and then go to hibernate remove check then click apply close it off.then see if you can restart
PLEASE LET ME KNOW IF THIS HELPED
IF NOT I CAN FURTHER ASSIST YOU

I am thinking that he just provided a set of drivers for this Laptop...

He simply put it there and said nothing...

I had the same problem. I took it to my nearest toshiba repair center, turned out the hard disk was defective/corrupt, the tech repair guy replaced it and it worked inmediately. Good Luck.