Welcome to FixYa
Indication of Router Lights:
A working router should show solid green power light.
upgrade the firmware of the router.
If this Helped you-Rate me..Thanks for Using FixYa
Still have any Problem for your Router Make a Reset....Keep Using...
×
SOURCE: weak wireless signal - WRT160N is a piece of trash
We found Linksys wifi units to be unusable a few years ago. I had a stack of them that the wifi had died or was unstable or short ranged and none of these were more than a year old. They have had quality problems for about 5 years. Tech support is handled overseas and consists of them reading off of cheat cards. If you get through to a tech you will find them not to understand any technical jargon and once not even normal non technical english.
Our "fix" (and what I'd reccomend if you want to avoidl headaches) was to yank out all remaining Linksys units and replace with a different brand. We didn't see any difference with the models, they all failed in some way. I don't know what happened to the company but they used to have a very good product. They don't have that now.
SOURCE: Cannot connect wirelessly to my Linksys WRT160n, but wired works
Get Network Magic ... download for evaluation.
This is a tremendous network management tool well worth the $. If you dont pay, you can still use most features.
Get it and use it to get your connection going at least.
Let me know what happens
a
SOURCE: Linksys WRT160n V2 Wireless-N broadband router was
Try hard resetting it for 1 minute to 2 minutes ; press and hold the reset button properly for that certain period and after that powercycle it.
SOURCE: WRT160N Wireless Router : linksys router wrtn160. where is the pin number...
You can find the pin number listed on the label on the bottom of the router.
The Linksys WRT160N has WPS (Wi-Fi Protected Setup). If you are using WPA-PSK encryption (recommended), then you can easily connect the C4780 to your wireless network using WPS:
1) On the Linksys router, press the WPS button that is top of the case just under the Cisco label. When the LED on the button starts to blink, then the WPS process has started.
3,589 views
Usually answered in minutes!
×