Can anyone tell me whats wrong with my panasonic pt46wt49. how can i fix the convergence on the top and the right and left of the screen i have replaced the ics (stk392-110)both of them and also tried to adjust the convergence on the service mode but did not help. the convergence if only off about half inch from the top of the screen and half inch from both side on the top its green and on the side its red and blue.so what could be wrong do i need to replace any thing else in the set and how could tell if the resister is bad. please help
thanks
neal
You need to check all the convergence resistors out of circuit 1 or 2 are most likely open and need to be replaced. You can get the service manual and free tech support at this link .
http://servicemanuals.vstore.ca/
59 views
Usually answered in minutes!
thank you for that answer i will do that
neal
×